Table of Contents
Brake Hoses and Pipes Inspection
Perform this inspection where there is enough light and
use a mirror as necessary.
Check brake hoses and pipes for proper hookup, leaks,
cracks, chafing and other damage.
Check that hoses and pipes are clear of sharp edges
and moving parts.
Repair or replace any of these parts as necessary.
Brake Fluid Change
Change brake fluid as follows.
1) Drain existing fluid from brake system completely.
2) Fill reservoir with specified brake fluid indicated on
reservoir cap. For the details, refer to
"Brake Fluid Level Check in Section 4A".
3) Carry out air purge operation, referring to "Air
Bleeding of Brake System in Section 4A".
Parking Brake Lever and Cable Inspection
1) Inspect brake cable for damage and smooth
movement.
Replace cable if it is in deteriorated condition.
2) Check tooth tip of each notch for damage or wear. If
S6JB0A0206018
any damage or wear is found, replace parking lever.
3) Check parking brake lever for proper operation and
stroke, and adjust it if necessary.
For checking and adjusting procedures referring to
"Parking Brake Check and Adjustment in Section
4D".
Parking brake lever stroke
"a": 5 – 7 notches (with 200 N (20 kg, 44 lbs) of
pull pressure)
I5JB0A020008-01
Clutch Fluid Inspection
S6JB0A0206019
1) Check system for evidence of fluid leakage.
Repair leaky point if any.
2) Check reservoir for fluid level referring to "Clutch
Fluid Inspection in Section 5C".
S6JB0A0206020
I5JB0A020023-01
Maintenance and Lubrication:
0B-12
I5JB0A020024-01
S6JB0A0206021
I5JB0A410005-01
Chapters
Table of Contents
