Table of Contents
6
Transport and storage
6.1
Safety
6.2
Transporting the Sytronix system
The components of the Sytronix system shall be transported in their original
packaging in compliance with classes 2K2, 2B1, 2C2, 2S2, 2M1 specified in DIN
EN 60721-3-2.
Sytronix systems can be transported using a fork lift truck or lifting gear.
● Make sure that the load-carrying capacity of your fork lift truck or lifting gear
Drain the coolant from liquid-cooled motors before transport to prevent frost
damage.
Please observe the following classification limitations:
● Transport temperature range -20 ... +80 °C
● Relative humidity of air max. 75 % (at +30 °C)
● No occurrence of salt mist
● Observe the transport instructions on the packaging.
RE 62312-B, 03.2022
Toppling over, falling or uncontrolled change in position
WARNING
of unsecured hydraulic components.
Unsecured Sytronix systems can topple over or fall down
and, in the case of heavy weight, bruise or strike persons
dead.
−
Observe the weight and the position of the center
of gravity of the Sytronix system. Use only suitable
lifting gear and, if required, industrial trucks for han-
dling the Sytronix system.
−
Do not stand under suspended loads. Ensure that no
unauthorized persons are within the danger zone.
−
For fixation and lifting of the product with lifting
gear, only use the eyebolts and lifting attachments
provided for this purpose. Observe the maximum
load-bearing capacity of the attachment devices and
industrial trucks.
−
Position the product on a suitable foundation.
−
Wear personal protective equipment.
−
Do not lift the motor and the pump at the shaft or at
the optional fan housing.
−
Comply with the national laws and regulations
regarding occupational health and safety for trans-
porting/handling.
Heavy loads!
CAUTION
Danger due to overload or not suited posture when
lifting and transporting!
−
When carrying the product, apply suitable techniques
for lifting, lowering and relocating or use suitable
lifting gear.
−
Don't transport the control system at sensitive
attachments (e.g. sensors or valves).
−
Put the control system carefully on the supporting
surface in order that it is not damaged.
is sufficient.
Sytronix SvP 7030 IMC
Transporting the Sytronix system
35 / 186
Bosch Rexroth AG
Table of Contents
