Motorola HMWS1060 Quick Start Manual
  1. Manuals
  2. Brands
  3. Motorola Manuals
  4. Security Sensors
  5. HMWS1060
  6. Quick start manual
Motorola HMWS1060 Quick Start Manual

Motorola HMWS1060 Quick Start Manual

Water sensor
Hide thumbs Also See for HMWS1060:
1
2
3
4
5
6
7
8
9
Table of Contents

Quick Links

Quick Start Guide
HMWS1060
Water Sensor
Table of Contents
loading

Related Manuals for Motorola HMWS1060

Summary of Contents for Motorola HMWS1060

  • Page 1 Quick Start Guide HMWS1060 Water Sensor...

  • Page 2: Water Sensor

    Product that is manufactured by Motorola and identified by Motorola owned trademark, trade name or product identification logos affixed to the Product. Motorola does not warrant to you, the end user, or to anyone else that the Software will perform error free or without bugs. MOTOROLA IS NOT RESPONSIBLE FOR, AND PROVIDES “AS IS”...

  • Page 3: Battery Life

    Motorola, Inc. Motorola reserves the right to revise this publication and to make changes in content from time to time without obligation on the part of Motorola to provide notification of such revision or change. Motorola provides this guide without warranty of any kind, either implied or expressed, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose.
  • Page 4 Sensor. Controlling Your Sensor Using your computer and the Gateway, you locally manage your home environment with the Motorola Home Monitoring & Control System. When configured, the system can notify you of any new events by sending an e-mail when your Water Sensor detects an event. An event is defined as a change from a wet or dry state where the tip of the water sensor probe is located.

  • Page 5: Installation Overview

    1.27 cm). If you paint your Motorola sensor, use a non-conductive latex paint. Remove the batteries from the sensor before painting and allow adequate time for the paint to dry before reinserting batteries. Make sure you do not let paint run into the openings of the sensors to prevent damage to the electrical circuitry.

  • Page 6: Attaching The Probe

    Water Sensor Mounting Your Water Sensor It is recommended that you discover your sensor before mounting it. Using the supplied double-sided tape, peel one-side of the paper strip and place it on the back of the sensor. Peel the other side of the tape and place the sensor in the location desired. You can also mount the sensor more securely using the screws in the hardware kit.

  • Page 7: Troubleshooting

    The battery is expected to last up to 12 months. This depends on actual use and how often the sensor is triggered. The Motorola Water Sensor includes a battery saving feature that causes the sensor to hibernate when there is no activity and wakes-up when the sensor is triggered. Do not use rechargeable batteries.
  • Page 8 Water Sensor Wall Mounting Drilling Template Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you pre-drill ½ inch deep pilot holes with a drill bit slightly smaller than the mounting screws before secur- ing the sensor to the surface. When mounting a sensor on soft surfaces like sheetrock, use an awl to punch holes in the material slightly smaller than the plastic anchors included in the hardware mounting kit.
  • Page 9 Visit our website at: http://www.motorola.com/homemonitoring 516951-001 11/04 MGBI...

Table of Contents