Table of Contents
FINAL DRIVE / WHEEL / TIRE
WHEEL AND HUB TORQUE TABLE
ITEM
SPECIFICATION
Torque: Steel Wheels:
36 ft-lbs (49 Nm)
Aluminum Wheels:
Wheels Nuts
30 ft-lbs + 90º (41 Nm +
90º)
90 ft-lbs (122 Nm)
Front Hub Nut
110 ft-lbs (150 Nm)
Rear Hub Nut
CV SHAFT BOOT INSPECTION
Inspect the CV shaft boots in the front and rear for
damage, tears, wear, or leaking grease. If the rubber
boot exhibits any of these symptoms, replace the boot.
Refer to Final Drive for CV boot replacement.
9928485 R01 - 2017-2018 RANGER 500 / 570 Service Manual
© Copyright Polaris Industries Inc.
WHEEL REMOVAL
RE-
DESCRIP-
NOTES
F.
TION
q
Wheel Nuts
Torque: Steel Wheels:
36 ft-lbs (49 Nm)
Aluminum Wheels:
30 ft-lbs + 90º (41 Nm + 90º)
w
Washers
1. Stop the engine, place the transmission in gear and
chock wheels.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing a suitable
stand under the footrest frame.
4. Remove the wheel nuts and washers and remove
the wheel.
MAINTENANCE
2
2.27
Chapters
Table of Contents
Troubleshooting
