RCA RS2929B - CD Music System Manual

SAFETY PRECAUTIONS

It's important to read this User Manual prior to using your new product for the first time.

FCC Information
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

For Customers in Canada
This apparatus complies with the Class B limits for radio noise emission set out in radio interference regulations. CAN ICES-3 (B) / NMB-3 (B)

On Safety

On Use
Never use the unit where it would be subject to:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

This product contains a low power laser device.

IMPORTANT SAFETY INSTRUCTIONS

LOCATION OF CONTROLS

REMOTE CONTROL

1. STANDBY/ON button
2. SLEEP button
3. /PROG/MEM button
4. RANDOM button
5. /MEM.UP button
6. STOP button
7. PRESEt EQ button
8. TIMER button
9. FUNCTION button
10. PAIR button
11. / TUNE – / + button
12. VOLUME +/– buttons
13. PLAY/PAUSE button

USING THE REMOTE CONTROL CORRECTLY

TO CHANGE REMOTE BATTERY

1. Open the battery door.
   
   
2. Insert one CR2025 (3V) size battery. control.
   
   
   ATTENTION
   Take out the plastic sheet before operating the remote control.
   

BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the remote control is greatly reduced and you will need to replace it.

NOTE: If the remote control is not going to be used for a long time, remove the battery to avoid damage caused by battery leakage corrosion.

Do not dispose of battery in fire; battery may explode or leak.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

SYSTEM CONNECTIONS

SPEAKER CONNECTIONS
Connect the right speaker to the R terminal and the left speaker to the L terminal.
NOTE: Connecting speakers other than the speakers supplied with the unit may damage the unit.

USING THE AC ADAPTER
Using an AC adapter other than the one supplied with the unit may damage the unit. This AC adapter operates on AC 100-240V ~ 50/60Hz.

LINE IN CONNECTION

CONNECTING TO LINE IN FOR OTHER SOUND SOURCES
You can connect audio devices such as your CD player or MP3 player to the unit via the LINE IN jack. To do this, connect an audio cable from the line out or headphone out jack of the other audio device to the LINE IN jack on the rear of unit. Press the FUNCtION button to switch to AUX mode.

Note: We recommend you unplug the device from the LINE IN jack when not in use.

CLOCK SETTING

Setting the clock can only be done in STANDBY mode.

1. Press and hold the /PROG/MeM button until the hour digits blink.
2. Press the button to adjust the desired hours and press the /PROG/MeM button once to confirm, then the minute digits blink.
3. Press the button to adjust the desired minutes and press the /PROG/MeM button once to start clock.

12:00 PM = NOON time, and "PM" appears.

LISTENING TO THE RADIO

1. Press the STANDBY/ON button to turn the unit on.
2. Press the FUNCTION button to switch to TUNER mode.
3. Press the button to tune in to a station.

Searching for a Station Automatically

• Press and hold the button until the tuner starts searching for a station, then release. After tuning in a station, the search stops.

Presetting Stations
The unit can store a total of 10 stations in memory. Presetting allows you to tune in to a station directly.

1. Press the /PROG/MeM button. The preset number will blink and the "MEM" indicator will be shown on the display.
2. Press the /MeM.UP button to select the preset number.

Tuning in to a Preset Station
Press the /MeM.UP button to select a preset number.

For Better Reception
Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds best.

Note: Do not connect the FM antenna to an outside antenna.
When the reception is good, the "STEREO" icon will appear on the display.

After listening to the radio, press the STANDBY/ON button to turn the unit off.

PLAYBACK VIA BLUETOOTH^®ENABLED DEVICES

The unit can be paired and connected to the Bluetooth® enabled devices such as a smart phone.

Note: You must disconnect the LINE IN cable and device from the unit when you are ready to pair and connect your Bluetooth® device.

INITIAL DEVICE PAIRING AND CONNECTION
In order to pair and connect your Bluetooth® device for the first time:

1. Press the StANDBy/ON button to turn on the unit. Press the FUNCtION button to Blue mode and " " is shown on the display. The Bluetooth® indicator light glows blue and flashes which means the unit is in Bluetooth® mode and ready to pair.
2. Press and hold the PAIR button on the unit for 3 seconds. The Bluetooth® indicator light will start flashing rapidly which means it is pairing.

Notes:

RECONNECTING A BLUETOOTH^® ENABLED DEVICE
Bluetooth® enabled devices must be reconnected when the device has been turned off or the unit has been turned off.

1. Press the StANDBy/ON button to turn on the unit. Press the FUNCtION button to Blue mode and "" is shown on the display. The Bluetooth® indicator light glows blue and starts flashing rapidly, and it auto searches for the last paired Bluetooth® device in memory.
2. Depending on your Bluetooth® device, your device may automatically connect to the unit. If the device does not automatically connect to the unit, press and hold the PAIR button on the unit for 3 seconds until the Bluetooth® indicator light starts flashing rapidly, then search for the "RS2929B" in its list of your Bluetooth® devices and select it.

PAIR AND CONNECT WITH ANOTHER NEW DEVICE
In order to pair the unit to a new device, you must first disconnect the currently paired and connected Bluetooth® device from the unit.

This system supports a variety of equalizers and sound effects.
During playback, press the PReSet eQ button to select a desired music mode. Each time the PReSet eQ button is pressed, the music mode will be changed to the next one as follows:

CD PLAYBACK

To Pause Playback

To Stop Playback

• Press the STOP button.

Skipping to Another track

• Press either the or button according to the desired direction.
  Press the button to skip to the start of the current track or skip to previous tracks. Press the button to skip to the beginning of the next track.

Locating a Particular Point on a track

Repeat Current track

Repeat the entire CD

Cancel Playback Mode

RANDOM PLAYBACK

All tracks on the disc can be played in random order (Using the remote control only).

Random Playback

Cancel Random Playback

A program of up to 20 tracks can be set to play in a preset order.

1. In CD stop mode, press the /PROG/MeM button and the "MEM" & "" will blink on the display.
2. Press the or button to select the desired track and press the /PROG/ MeM button to store the track in memory.
3. To start playback, press the PLAY/PAUSE button.

To check the program:

To change the programmed tracks during program playback:

To erase the whole program, do one of the following:

• Press the FUNCtION button to the other mode.
• Press the StOP button and open the CD door.

TIMER SETTING

The timer function will turn the unit on at a preset time.

TO SET TIMER

TO CANCEL TIMER

The sleep timer automatically turns the unit off at a certain time.

TROUBLESHOOTING GUIDE

LIMITED WARRANTY

Out of Warranty
In the event your product requires repair after the limited warranty period has expired, please contact our Customer Support Center at 1-800-506-5746, 1-877-252-6873 or www.RCAav.com
Hours: Monday–thursday: 9am–7pm, Friday: 9am–5pm, Saturday: 9am–NOON eastern time.

You are responsible for any transportation, shipping or insurance relative to the return of product to our Product Returns Center.

For more information on other products and services, please visit our web site at www.RCAav.com

Also keep your "Bill of Sale" as proof of purchase.

Model no:
Product name:
Type of set:
Serial no:
Invoice no:
Date purchased:
Dealer name:

FOR SERVICE AND REPAIR, PLEASE VISIT www.RCAav.com
Specifications and external appearance are subject to change without notice.
© 2013 AVC MULTIMEDIA