Table of Contents
5. Install brake disc and caliper assembly. Torque brake
caliper fasteners to specification.
TORQUE
Front Caliper Mounting Bolts:
73 ft-lbs (100 Nm)
6. Install front knuckle assembly and axle nut. Torque
NEW axle nut to specification.
TORQUE
Wheel Axle Nut:
89 ft-lbs (120 Nm)
7. Install the steering tie rod end onto the front steering
knuckle.
8. Torque the tie rod end fastener to specification.
TORQUE
Tie Rod End Fastener:
52 ft-lbs (70 Nm) + 90°
9. Install wheel and five wheel nuts. Torque wheel nuts
to specification.
TORQUE
Wheel Nuts:
148 ft-lbs (200 Nm)
10. Rotate wheel and check for smooth operation.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
REAR BEARING CARRIER INSPECTION
/ REMOVAL
1. Elevate rear of vehicle and safely support machine
under the frame area.
WARNING
Serious injury may result if machine tips or falls. Be
sure machine is secure before beginning this service
procedure. Wear eye protection when removing
bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smoothly without binding or
rough spots.
3. Remove the wheel nuts and rear wheel.
q
4. Remove rear axle nut
from the rear wheel hub
assembly.
5. Remove the radius rod outer mounting bolts
and washers from the bearing carrier. Swing radius
rods down.
6. Remove half shaft from knuckle assembly.
FINAL DRIVE
8
w
, nuts
8.5
Chapters
Table of Contents
Troubleshooting
