Table of Contents
PVT SYSTEM
4. Install the clutch cover
Hand tighten bolts.
5. Torque cover bolts in a cross pattern evenly to
specification.
TORQUE
Drive Clutch Cover Bolts:
15 ft-lbs (21 Nm)
6.18
i
and clutch cover bolts
DRIVE CLUTCH INSTALLATION
o
.
1. Install drive clutch stationary sheave.
2. Install drive clutch moveable sheave and drive clutch
retaining bolt
Drive Clutch Retaining Bolt:
Step 1: 140 ft-lbs (190 Nm)Step 2: Loosen two full
turns (720°)Step 3: 118 ft-lbs (160 Nm)
When drive clutch is fully installed, the spring coupler
between the engine and drive clutch may allow up to
approximately 30 degrees of free rotation when turning
clutch by hand. This rotation range is normal.
3. Install the drive belt.
4. Install outer clutch cover. Install five fasteners
engage 1/4 turn latches to secure the cover. Torque
fasteners to specification.
Outer PVT Cover Fasteners:
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
u
. Torque fastener to specification.
TORQUE
NOTICE
TORQUE
60 in-lbs (7 Nm)
© Copyright Polaris Industries Inc.
e
and
Chapters
Table of Contents
Troubleshooting
