Table of Contents
CLUTCH ASSEMBLY
NOTICE
The Teflon® bushings are self-lubricating.
CAUTION
Do not apply oil or grease to the bushings.
Reassemble the drive clutch in the following sequence.
Be sure the "X", or the marks that were made earlier are
aligned during each phase of assembly.
q
1. Install two washers
, needle bearing
e
spacer
onto the stationary sheave in the order
shown.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
2. Install clutch spider as shown
If necessary, once the splines are aligned properly, an
arbor press may be used to properly seat the clutch
3. Install washer
u
spring
Belleville washer must be installed with dome facing the
w
, and clutch
PVT SYSTEM
r
.
NOTICE
spider.
t
y
, belleville washer
, and clutch
.
IMPORTANT
outer post.
6
6.17
Chapters
Table of Contents
Troubleshooting
