Installing The Planetary Gearbox With Axial-Piston Motor Connection (Axial- Piston Motor Is Not Included In The Scope Of Supply) - Bosch Rexroth MOBILEX GFT-W 30 Series Operating Instructions Manual

Winch drives for mobile and stationary applications
Table of Contents
38/86
Assembly
Procedure
Bosch Rexroth AG
, MOBILEX GFT-W general operating instructions series 30, RE 79100-01-B/11.2020
7.5.4 Installing the planetary gearbox with axial-piston motor connection (axial-
piston motor is not included in the scope of supply)
Failure or damage to the planetary gearbox!
If you install the planetary gearbox in any other installation position than the one
permitted by Rexroth, the planetary gearbox may be damaged or fail. The
warranty claim lapses!
Only install the planetary gearbox in an approved Rexroth mounting position
as indicated in the dimensioned drawing in appendix D "Technical data /
Drawings" of the material number-specific operating instructions.
Observe the operating instructions of the axial-piston motor manufacturer (not
included in the scope of supply). This is where you will find all the required
information on assembly and commissioning of the axial-piston motor.
If the planetary gearbox is delivered without the axial-piston motor, install as
follows:
• Assemble the planetary gearbox to the cable drum
• Assemble the planetary gearbox to the equipment frame or winch base.
• Then assemble the axial-piston motor to the planetary gearbox.
To install the planetary gearbox on the cable drum and then in the equipment
frame or winch base:
1
For installation, strictly observe the corresponding data in the dimensioned
drawing of the planetary gearbox in appendix D "Technical data / Drawings" of
the material number-specific operating instructions.
2
Also observe the primary operating instructions of the crane or winch
application and the manufacturer's frame drawing or winch base.
3
For the planetary gearbox weight, refer to appendix D "Technical data /
Drawings" of the material number-specific operating instructions.
4
Transport the planetary gearbox to the crane or winch application.
5
Make sure that the surface is stable.
6
Place the planetary gearbox with the cover plate down on two suitable squared
timbers. Secure the planetary gearbox against tipping over.
CAUTION
Table of Contents
loading

Table of Contents