Before Starting Wireless Connection Setup
1. Make sure that the printer is turned on.
If the power is on, the POWER lamp (A) will be lit.
The network connection setup is now complete.
Before Starting Wired Connection Setup
Notes on Wired Connection
You will need an Ethernet cable (sold separately).
The network connection setup is now complete.
When the (blue) Wi-Fi lamp flashes slowly and the (orange) Alarm lamp is lit:
After checking the above points, wait for a while and configure wireless connection setting again.
For details on how to check the security settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
When the (blue) Wi-Fi lamp flashes quickly and the (orange) Alarm lamp is lit:
Wait for a while, then bring the access point and printer close to each other, and configure wireless connection settings again within a specified time.
For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer.
To configure wireless connection settings again
To configure wireless connection settings again, press the RESUME/CANCEL button (A).
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the PIXMA PRO-100 Series that isn't answered in the manual? Leave your question here.