JVC C4G Instructions

Using the Built-in Tilt Stand

Complete

Figure

You can use the stand to place the camera on the floor or table

to shoot from a low angle or when taking a selfie.

1. ① Place your finger at the 　

　indent of the stand located

　at the bottom of this unit.

② Move your finger in the 　

　direction of the arrow.

・The front edge of the stand lifts

up.

2. ① Lift the stand upright.

　② Slide the stand in the 　　

　direction of the arrow to the

　position indicated by the 　

　line in the figure.

If the stand does not move, do

・

not force it. Proceed to step 3.

3. Tilt the stand as shown in the figure.

Place the camera as shown in the

・

complete figure.

■ Storing the stand

① Lift the stand upright and slide

　 it in the direction of the arrow.

② Align the marks on the camera

Indent

　 and the stand.

③ Flip the stand down to store.

Front Edge

Caution

If the stand is detached, reattach the stand immediately as instructed in the

Detailed User Guide to avoid losing it or accidentally swallowing it.

Dtailed User Guide: http://manual3.jvckenwood.com/c4g/ah/

Approx. 2 mm

B5H-0029-00

C4G

0514TOH-SW-VM

Mark