Dell AP-130-MNT-C2 Installation Manual

AP-130-MNT-C2

Installation Guide

The AP-130-MNT-C2 ceiling rail adapter provides additional ceiling mounting options for the 130 Series

wireless access point (AP). The ceiling mounting kit includes the following items:

Adapter for Open (Silhouette) ceiling tile rails. The wider of the two adapters.



Adapter for Flanged (Interlude) ceiling tile rails. The narrower of the two adapters.



For complete information about selecting the location and setting up the AP, see the 130 Series Access

Point Installation Guide.

Installation

To attach either ceiling rail adapter to the AP:

1. Place the adapter against the back of the AP with the adapter at an angle of approximately 30 degrees to

the tabs (see

2. Twist the adapter clockwise until it snaps into place in the tabs (see

Figure 1 Adapter Installation

After the adapter is attached to the AP, mount the AP on a ceiling tile rail as follows:

1. Align the AP with a ceiling tile rail, placing the AP so that the mounting tabs on the adapter are at an

angle of approximately 30 degrees to the ceiling tile rail (see

Make sure that slack in connected cables is above the ceiling tiles.

2. Pushing toward the ceiling tile, rotate the AP clockwise until it clicks into place on the ceiling tile rail

(see

Figure 2

0511077-02

| August 2013

Figure

1).

or

Figure

3).

Figure

1).

Figure 2

or

Figure

3).

1