Quick Links
Wireless LAN Board-C1
Installation procedure
If bundled parts are used;
If the parts bundled with this product are used, the symbol indicating the use of
bundled parts is illustrated.
Bundled
parts
In this procedure manual, the frequent operations are illustrated with symbols.
Screw
Connector
Attach
Detach
Attach
Claw
Attach
Detach
Push
Check Visual check Noise check
Binding wire
Detach
Attach
Detach
Plug in
Switch ON
Check of bundled parts
[1] Wireless board x 1
[2] Flat cable x 1
1-1
[3] Screw (TP;M3x6) 1
1-1
Summary of Contents for Canon Board-C1
- Page 1 Wireless LAN Board-C1 Check of bundled parts Installation procedure [3] Screw (TP;M3x6) 1 [1] Wireless board x 1 [2] Flat cable x 1 If bundled parts are used; If the parts bundled with this product are used, the symbol indicating the use of bundled parts is illustrated.
- Page 2 Check of main power OFF Installation procedure Check that the main power switch of the main body is OFF. 1) Turn OFF the main power switch of the main body. 1) Press cassette [1]. 2) Check that the indication lamps on the operation panel and the main power 2) Press button [2].
- Page 3 4) Remove claw [1] and arm cover [2]. 6) Shift the left side of main body [1] from the workbench by about 10 cm. 5) Disconnect arm [1] and push it back. 7) Open ADF unit and reader unit [1]. Reset claw [2].
- Page 4 8) Open ADF unit and reader unit [1]. While applying stress to left cover [2] in 9) Reset two bottom claws [2] with left cover [1] opened in the arrow the arrow direction, reset claw [3]. direction. 10) Open ADF unit and reader unit [1]. Reset claw [3]. Memo Remove the claw with right cover edge [2] reset from four rear cover hooks [1].
- Page 5 11) Open ADF unit and reader unit [1]. Remove boss [2] from left cover [3]. 14) Remove connector [1] from the counter board. Wire saddle [2] 12) Remove left cover [3]. 15) Remove controller cover [1]. Memo Six screws [2] (Removed screws are used in step 19).) For attachment, attach left cover [1] aligning with four protrusions [2] on the left ...
- Page 6 17) Attach Wireless board [1]. 16) Attach Flat cable [1] on the main controller board [2]. ・Hook [2] ・Screw [3] (TP;M3×6) CAUTION: ・Insert the Flat Cable face up. 18) Attach Flat cable [1] on the W-LAN board [2]. 19) Put all covers back. ・Control cover ・Left cover...
-
Page 7: Fcc Warning
Note ■Put following sentences outside of the host device if the FCC ID on the module cannot be seen from exterior. ・“Contains Transmitter Module FCC ID: AZDFM48944” or “Contains FCC ID: AZDFM48944” ・“Contains Transmitter Module IC: 498D-FM48944” or “Contains IC: 498D-FM48944” ■User’s manual of the host device should contain sentences listed below.