Table of Contents
Quick Links
NOV2021
WH1 / WH2 / EM1 / EM2
Whole House Water Filtration Systems
For correct operation & installation, it is essential to observe these instructions.
SURGE PROTECTION
REQUIRED /
NO EXTENSION CORDS.
181
209
181
User Guide
379
181
209
181
379
181
209
181
379
209
150
209
379
209
345
150
379
DO
DO
LIQ
SU
RE
1
NO
209
209
Table of Contents
Related Manuals for Watermark Puretec WH1
Summary of Contents for Watermark Puretec WH1
- Page 1 SURGE PROTECTION REQUIRED / NO EXTENSION CORDS. User Guide WH1 / WH2 / EM1 / EM2 Whole House Water Filtration Systems For correct operation & installation, it is essential to observe these instructions. NOV2021...
-
Page 2: Table Of Contents
What's Inside What's Inside Introduction ..........................2 Guidelines and Warnings ..................... 3 Positioning Your Filter ......................3 Installation Procedure ......................4 Typical Installation ........................4 Replacement Guide ......................... 5 Cartridge Installation / Replacement ................5 Replacement Parts List ......................6 Warranty ............................ -
Page 3: Introduction
Introduction Guidelines and Warnings • Pressure: 200 - 875 kPa. Note: Where line pressure exceeds 500 kPa, an approved pressure limiting device must be installed to comply with Australian & New Zealand Plumbing Standards. • Protect the housing from water hammer. •... -
Page 4: Installation Procedure
Installation Guide Installation Procedure Isolate water supply and relieve pressure by opening a downstream tap. Cut pipe to suit length of required valve and housing installation. Use approved brass, galv/poly plumbing fittings to suit existing pipework. The female threads on the housing will receive tapered male threads. Thread into housing head carefully as too much tape or overtightening may cause it to split. -
Page 5: Replacement Guide
Maintenance Replacement Guide You can obtain replacements from your local Puretec dealer. To maintain performance, warranty and standards use genuine Puretec replacements. WH Replacements WH1-30 CB10MP1 WH1-60 CB10MP2 WH2-30 / WH2-35 PX05MP1 CB10MP1 WH2-55 / WH2-60 PX05MP2 CB10MP2 EM Replacements EM1-60 DP10MP1 EM1-110... -
Page 6: Replacement Parts List
Maintenance Clean bowl(s) with soap and warm water and rinse thoroughly. Check O-Ring(s) for damage and if there is any, replace. Check O-ring(s) lubrication and if necessary apply a light coating of food grade silicone lubricant (or similar). Remove all packaging from new filter cartridge(s) and insert into housing bowl(s) making sure cartridge(s) is properly seated over spigot in base of bowl(s). -
Page 7: Warranty
Warranty Notes Puretec water care products are designed, manufactured and supported by Puretec Pty Ltd the name you can trust for viable and proven water solutions. The complete range of Puretec products are developed, refined, made to meet and exceed stringent specifications for the worldwide market. Important: Sales of products are subject to our Terms and Conditions which are available upon request.