Quick Links
3
Immersion Heater
CYLINDER UNIT OPTIONAL PARTS
IMMERSION HEATER (1Ph 3kW)
PAC-IH03V2-E
● Before starting installation, read the following description together with the installation manual included with the cylinder unit.
● Please read carefully and observe fully the following safety precautions.
WARNING
Precaution that must be observed to prevent injuries or death.
●
After installation carry out a test run to ensure correct operation, then explain operation method and safety precautions to the
end user.
Tell your customers to keep this installation manual together with the operation manual, and when they give or sell this
machine to any other person include this installation manual and operation manual with it.
●
If the cylinder has already been connected to the power supply ensure circuit breaker is off before carrying out electrical
work.
●
If the immersion heater is installed incorrectly or modified after installation by the user, water leakage, electric shock or
fire may result.
●
All electrical work should be performed by a qualified technician according to local regulations and the instructions given
in this manual.
●
The immersion heater must be powered by a dedicated power supply and the correct voltage and correctly sized circuit
breakers must be used.
●
Connections must be made securely and without tension on the terminals.
The included component parts of the PAC-IH03V2-E IMMERSION HEATER (1Ph 3kW) shall be used only for the
purposes indicated in the installation manual.
INSTALLATION MANUAL
WARNING
Optional parts
D-25
Related Manuals for Mitsubishi Electric PAC-IH03V2-E
Summary of Contents for Mitsubishi Electric PAC-IH03V2-E
- Page 1 ● Connections must be made securely and without tension on the terminals. The included component parts of the PAC-IH03V2-E IMMERSION HEATER (1Ph 3kW) shall be used only for the purposes indicated in the installation manual. D-25...
- Page 2 Immersion Heater Optional parts Contents Item Piece Immersion heater Thermostat (High limit thermal cut-out) Tab cover Earth leakage breaker Screw (4×25) Relay Screw (4×16) Label (for Earth leakage breaker) Label (for Relay) Lead wire with connector Lead wire (Red, 130mm) Lead wire (Blue, 130mm) Lead wire (Red, 1500mm) Lead wire (Blue, 1500mm)
- Page 3 Immersion Heater Optional parts Check before starting installation that no water is in the tank. Diagonally locate the thermostat pockets on upper right and bottom left with terminals on the upper left and bottom right sides as shown. Secure tightly with the nut to prevent water leakage. The blanking plate and gasket (Recommended torque = 10 N•m) can be removed using a narrow...
- Page 4 Immersion Heater Optional parts Run the lead wire through the slit on the water-proof cover provided and seal each terminal screw. Do not insert the lead wires 3 and 4 into the opening that the main controller wires or the wireless receiver wires use.