SENSOR PAD ALARM
Model #
Description
909350
ChairPro Sensor Pad Alarm
w/7"x15" 45-day sensor pad
909355
ChairPro Sensor Pad Alarm
w/7"x15" 180-day sensor pad
909356
ChairPro Sensor Pad Alarm
w/7"x15" 1-Year sensor pad
909430
ChairPro Sensor Pad Alarm
w/16"x16" 45-day sensor pad
909434
ChairPro Sensor Pad Alarm
w/16"x16" 180-day sensor pad
See reverse side for replacement sensor pad ordering information.
GUARANTEES
1. The ChairPro Safety Alarm Unit is replacement guaranteed
for one year following the date of purchase.
2. The ChairPro sensor pads are replacement guarantee
for either 45 days or 180 days (see guarantee imprint on
sensor pad) following the date they are put into service. That
date must be noted on the pad for this guarantee to be effective.
These guarantees cover defects in materials and workmanship under
conditions of normal use. Please return defective part to dealer from
whom it was purchased. The dealer will send the defective part to
Skil-Care and arrange for shipment of a replacement.
The ChairPro Sensor Pad Alarm is designed to alert caregivers when
a patient/resident has left or fallen from the wheelchair.
1.
The ChairPro Sensor Pad Alarm is not a substitute for proper super-
vision. Fall-risk residents/patients should be monitored regularly.
2.
Check battery each time alarm is used. If weak, replace the 9-volt
battery.
3.
LED should glow when patient/resident is seated on the sensor
pad. If LED fails to glow, check battery. Replace if necessary. If LED
does not glow after battery is replaced, check sensor pad.
4.
If patient/resident is seated on a wheelchair cushion, place sensor
on top of cushion. This system will not work if sensor is placed
beneath cushion.
Alarm unit made in China. Instructions printed in USA.
Unit
Each
Each
Each
Each
Each
PURPOSE
CAUTIONS
29 Wells Avenue
914-963-2040
Yonkers, NY 10701
800-431-2972
INSTALLATION
Alarm Unit
You may choose one of the following two ways
to attach the alarm unit to the wheelchair.
Mounting Bracket
1.
Remove the second
from-top screw from either
the left or right side of the
wheelchair backrest.
2. Remove grommet from
screw,
place
the
screw
through hole on alarm unit
mounting bracket, and fasten
screw to wheelchair backrest.
(Illustration A)
Cord Loop
B
1.
Insert enclosed cord
loop through bracket
hole. (Illustration B)
Continued on reverse side.
Mounting Bracket
LED
A
C
2.
Hang from wheel-
chair
push-handle
(Illustration C)