Table of Contents
PVT / FINAL DRIVE / WHEEL AND TIRE MAINTENANCE
PVT INTAKE PRE-FILTER SERVICE
It is recommended that the PVT intake pre-filter be
inspected daily. The filter should be inspected using the
following procedure:
1. The PVT intake pre-filter is located just behind the
passenger hip bolster on the right side of the vehicle.
The pre-filter is adhered to the back of the body
panel.
2. Inspect the pre-filter. Wipe away any deposits with a
clean cloth.
3. If necessary, remove the body panel and clean the
pre-filter with soapy water and dry with low pressure
compressed air.
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
PVT DRYING
NOTICE
After operating in water, the vehicle's PVT system
should be checked immediately. Use the following
instructions to dry it out before operating.
The PVT drain plug is located at the bottom of the outer
clutch cover. Access the drain plug through the left rear
wheel well.
1. Using a flat blade screwdriver, remove the PVT drain
q
plug
and O-ring from the outer clutch cover.
2. Allow the water to drain out completely.
3. Reinstall the drain plug and O-ring.
4. Place the transmission in PARK, apply the brake and
start the engine.
5. Apply varying throttle for 10-15 seconds to expel the
moisture and air-dry the belt and clutches.
NOTICE
Do not hold the throttle pedal wide open for more than 5
seconds.
6. Allow the engine RPM to return to idle, then shift the
transmission into low gear.
7. Test the PVT system for belt slippage. If the belt
slips, repeat the process or remove the outer clutch
cover to inspect the PVT system (Refer to "PVT
System Service"page 5.7 for service and removal
procedures).
NOTICE
If the vehicle has ingested a large amount of water into
the PVT system and has not been operated for a period
of time, be sure to check the PVT system components
for water damage.
MAINTENANCE
2
2.31
Chapters
Table of Contents
Troubleshooting
