Quick Links
Recoil Kit
22in Recycler
Model No. 139-6623
Model No. 139-6624
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
No parts required
Engine-shroud assembly
Recoil-starter-rope stop
Kit Model 139-6623 includes an engine shroud with a textured finish and kit Model 139-6624 includes an engine
shroud with a glossy finish. These kits can be used interchangeably according to your preference.
Preparing the Machine
1.
Shut off the engine, wait for all moving parts to stop, and allow the machine to cool before servicing it.
2.
Remove the 3 nuts holding the engine-shroud assembly onto the engine and then remove the old
engine-shroud assembly.
Note:
Retain the nuts for use in Step
Installing the Shroud Assembly and Rope Stop
1.
Secure the new engine-shroud assembly onto the engine with the previously removed nuts.
2.
Install the recoil-starter rope in the rope guide as shown in
3.
Hold the blade-control bar against the handle.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
or Super Recycler
Qty.
–
Prepare the machine.
1
Install the kit.
1
1
of
Installing the Shroud Assembly and Rope Stop (page
Figure 1
Register at www.Toro.com.
Form No. 3431-176 Rev A
®
Lawn Mower
Installation Instructions
Use
Figure
1.
Original Instructions (EN)
All Rights Reserved *3431-176* A
Printed in Mexico
1).
g230719
Related Manuals for Toro 139-6623
Summary of Contents for Toro 139-6623
- Page 1 Install the kit. Recoil-starter-rope stop Kit Model 139-6623 includes an engine shroud with a textured finish and kit Model 139-6624 includes an engine shroud with a glossy finish. These kits can be used interchangeably according to your preference. Preparing the Machine Shut off the engine, wait for all moving parts to stop, and allow the machine to cool before servicing it.
- Page 2 Pull the recoil-starter rope 2.5 cm (3/4 inch) out from the engine shroud (A of Figure With the rope pulled out, install the recoil-starter-rope stop onto the rope as close to the engine as possible (B of Figure Secure the recoil-starter-rope stop onto the rope by pinching it with a pliers (C of Figure g283560 Figure 2...