Table of Contents
Maintenance
Choke Adjustment - Mikuni TM
1. Flip the choke toggle to the "OFF" position.
2. Loosen locknuts (1) on the carburetor.
3. Turn sleeve adjusting nut (2) counter-clockwise until
the choke toggle shows no free play when pulled, then
rotate it clockwise until there is between 1/8 - 1/4in
(3.2-.6.4mm) free play (3).
NOTE: Verify the cable does not lift the plungers
when checking the free play.
1/8 - 1/4in. (3.2-6.4mm)
4. Tighten adjustment locknut (2).
3.20
STEERING / SUSPENSION
MAINTENANCE
Handlebars
Periodically inspect the torque of the handlebar clamp
fasteners.
2
1
1. To adjust the handlebar angle, remove the handlebar
2. Loosen the four clamp fasteners. Slightly pry the
3. Adjust handlebars to desired position. Verify the
4. Secure the front clamp fasteners first to 11 - 13 ft.lbs.
3
5. Reinstall the handlebar cover.
9923396 - 2007-2012 EDGE/Widetrak LX Service Manual
©2011 Polaris Sales Inc.
STEERING POST
cover to expose the clamp.
upper clamp up with a flat blade screwdriver.
wiring harness, brake hose, and throttle cable do not
kink.
(15 - 18 Nm). Finish by securing the two rear clamp
fasteners to the same torque setting.
= T
Handlebar Clamp Fastener Torque
11 - 13 Ft.Lbs. (15 - 18 Nm)
CLAMPS
- Quick Links:
- 2009 Trail Touring
Hide quick links:
Chapters
Table of Contents
Troubleshooting
