Page 1
HHC12 Series 12-Inch Camera Enclosure Install Guide Document 800-04354 – 04/09 – Rev A...
Page 2
Revisions Revision Date Revisions 04/09 New document updated to Honeywell standards, based on 900.0559 Rev A Document 800-04354 04/09...
Page 3
Warnings Installation and servicing should be performed only by qualified and experienced technicians to conform to all local codes and to maintain your warranty. WARNING! The use of CSA Certified/UL Listed Class 2 power adapters is required to ensure compliance with electrical safety standards. Explanation of Graphical Symbols CAUTION THIS SYMBOL INDICATES THAT...
Introduction The HHC12 Series camera housings are stylishly and functionally designed for 1/2" and 1/3" CCD cameras with fixed focal length or small zoom lenses. Features • Contemporary design • Die-cast and extruded aluminum construction • Adjustable mounting rack •...
Four #14 1-1/4 sheet metal screws If any parts are missing or damaged, contact the dealer you purchased the housing from or call Honeywell Customer Service (see back cover). Equipment Required You may require the following tools (not supplied) to complete the installation:...
Installation To correctly install the heater/blower and mount the camera, please follow the instructions in the order provided. Preparing for Installation Loosen but do not remove the screw that secures the sunshield in place. Turn the screw no more than 5 times. Detach the sunshield by sliding it backward on the main housing unit.
Unlatch the lid and open the upper body. Remove the desiccant bag from the protective packaging and place the bag inside the housing to absorb moisture. Close the housing. Locate the gold, 1/4” x 20 panhead UNC screws and set them aside for use later. Connecting the Heater/Blower (HHC12WM2 Model Only) Feed the external power supply (not included) through one of the compression...
Mounting the Camera This section describes how to install a camera into any of the HHC12 Series camera housings. Remove the mounting plate from the lower body by unscrewing one Philips panhead screw. Set the screw aside. 2. Tilt the mounting plate.
Reassemble the housing unit by closing the upper body and latching the lid tight. 6. Latch the lid. If applicable, reinstall the sunshield by sliding it across the top of the housing. Mounting the Wall Bracket To mount the wall bracket: Use fasteners of an appropriate size and type to attach the bracket to the wall surface.
Maintenance Regularly scheduled maintenance prolongs the operational life and appearance of equipment. On a regular basis, do the following: • Maintain picture quality by cleaning the viewing area window with a soft cloth and a mixture of mild detergent and water. •...
Specifications Housing Specifications Dimensions: 6.0 x 4.6 x 15.9 in (with sunshield) (153 x 118 x 406 mm) Weight: HHC12WM2 6.2 lbs (2.8 kg) (without mount) Max. camera size: Accommodates camera/lens combinations (including BNC) up to: HHC12WM 3.1 x 3.2 x 11.4 in (78 x 82 x 290 mm) HHC12WM2 3.1 x 3.2 x 9.0 in (78 x 82 x 230 mm) Viewing area:...
Page 15
Heater (HHC12WM2) Specifications Power Supply: 24 VAC Power Consumption: 20 W Heater ON: Heater turns ON at 41°F (5°C) Heater OFF: Heater turns OFF at 59°F (15°C) Blower (HHC12WM2) Specifications Power Supply: 24 VAC Power Consumption: 3.4 W Blower ON: Blower turns ON at 95°F (35°C) Blower OFF: Blower turns OFF at 68°F (20°C)