Ecu Removal / Replacement - Polaris Sportsman XP 1000 S 2020 Service Manual
Hide thumbs
Also See for Sportsman XP 1000 S 2020:
- Owner's manual for maintenance and safety (154 pages)
Table of Contents
ECU REMOVAL / REPLACEMENT
1. Remove the seat and upper side panels from the
vehicle.
2. Remove the (4) push rivets from each front mud
guard and remove the mud guards from the vehicle.
3. Remove the front rack or storage box assembly.
4. Disconnect the negative (-) battery cable.
NOTICE
Be sure to cover fuel tank inlet with a shop towel prior to
front cab removal.
5. Remove the front cab assembly
q
6. Remove the bolts
retaining the ECU to the ECU
w
bracket mount
.
7. Disconnect the wire harness from the ECU by pulling
the black slider out away from the ECU while pulling
down on the connector. Once the slider is fully
extended, pull the connector from the ECU, using
care not to damage the connector or locking
mechanism.
8. Carefully remove the ECU from the vehicle.
9. To install, reverse the previous steps. DO NOT apply
dielectric grease to the connector, as it is a sealed
connector.
NOTICE
If replacing the ECU, you must reflash the new ECU
with the correct calibration upon installation and prior to
attempting to start the vehicle.
9931493 R03 - 2020-2021 Sportsman XP 1000 S Service Manual
© Copyright Polaris Inc.
ENGINE ELECTRICAL
4.13
4
Chapters
Table of Contents
Troubleshooting
