Table of Contents
BATTERY INSTALLATION
CAUTION
Using a new battery that has not been fully charged can
damage the battery, result in a shorter life and hinder
vehicle performance.
1. Ensure the battery is fully charged.
2. Place the battery in the battery holder and secure
with hold-down strap.
3. Coat the terminals with dielectric grease or
petroleum jelly.
4. Connect and tighten the red (positive) cable(s) first.
5. Connect and tighten the black (negative) cable (s)
last. Torque terminal fasteners to specification.
TORQUE
Battery Terminal Fasteners:
60 in-lbs (7 Nm)
6. Verify that cables are properly routed and reinstall
the driver's seat.
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
ENGINE / CHASSIS ELECTRICAL GROUND
Inspect the ground cable connections. Remove ground
terminals and clean if necessary.
1. Located below the start solenoid
w
ground connection
can be accessed through the
left rear wheel area.
2. Inspect the chassis ground terminals. Be sure the
grounds are clean and tight.
MAINTENANCE
q
, the chassis
2
2.41
Chapters
Table of Contents
Troubleshooting
