Table of Contents
TEMP / MANIFOLD ABSOLUTE PRESSURE SENSOR (T-MAP)
TMAP OPERATION OVERVIEW
Mounted on the intake plenum, the T-MAP sensor
performs two functions in one unit.
Air passing through the intake is measured by the T-MAP
and relayed to the ECU. These signals, comprised of
separate air temperature and manifold absolute pressure
readings, are processed by the ECU and compared to its
programming for determining the fuel and ignition
requirements during operation. The T-MAP sensor
provides the ECU with engine load data.
9850045 R01 - 2020-2021 RANGER 1000 Service Manual
© Copyright Polaris Inc.
ENGINE ELECTRICAL
T-MAP SENSOR REPLACEMENT
1. Lift the rear cargo box to the raised position.
2. Disconnect the vehicle harness
sensor.
3. Remove the T-MAP sensor retaining fastener
remove the sensor from the intake plenum.
4. Apply silicone lubricant to the new sensor o-ring and
install the new T-MAP sensor into intake plenum.
5. Install the T-MAP sensor retaining fastener and
torque to specification.
TORQUE
T-MAP Retaining Fastener:
3 ft-lbs (4.5 Nm)
T-MAP SENSOR TEST
The T-MAP sensor is a non-serviceable item. If it is
faulty, it must be replaced.
IMPORTANT
This sensor should only be tested using the Digital
Wrench® Diagnostic Software (dealer only).
q
from the T-MAP
4
w
and
4.23
Chapters
Table of Contents
Troubleshooting
