Skil-Care 701010 Quick Start Manual

Visit us online

at Skil-Care.com

RESIDENT-RELEASE NYLON BELTS

Reorder #

Product Description

q701010

RESIDENT-RELEASE BELT

q701011

RESIDENT-RELEASE BELT

q701015

RESIDENT-RELEASE BELT

q701030

RESIDENT-RELEASE BELT

q701031

RESIDENT-RELEASE BELT

q701035

RESIDENT-RELEASE BELT

Resident-Release Nylon Belts are designed to be released easily by most residents. These belts are not con-

sidered to be restraints when used by residents who have the ability to open them at will or upon request.

However, they become physical restraints when used by residents who are unable to release them. The deter-

mination of the appropriateness of any of these belts for a specific resident is the responsibility of the profes-

sional and medical staff. These belts are intended for wheelchair use only.

Each belt listed above may be attached to a wheelchair using either of the methods described below.

METHOD A.

1. Remove the bottom screws from the left and right sides of the wheelchair

backrest. (See Illustration A.) Keep the grommets.

2. Place the grommets on the screws. Insert the screws through the holes in

the metal tabs on the ends of the belt sections. Reinsert the screws into the

screw holes and secure them to the backrest frame.

Before seating the resident, lock both wheelchair brakes and adjust the footrests to the out-of-way position.

Seat the resident as far back on the wheelchair seat as possible. Position the footrests to the front of the wheel-

chair and place the resident's feet on them.

Side-Release Buckle (See Illustration C) Insert the male

end of the buckle into the female end. A "click" indicates

that the buckle is secure. To release, simultaneously

press the tabs on the top and bottom of the buckle.

Resident-Friendly Buckle (See Illustration D) Lift faceplate of the buckle and insert

the webbing through the space between the buckle cam and buckle base. Press face-

plate all the way down to secure the buckle. To release, lift up the loose end of the

webbing.

PURPOSE

INSTALLATION TO WHEELCHAIR

METHOD B.

1. Remove the rear screws from the left and right sides of

the wheelchair seat. (See Illustration B.) Keep the

grommets.

2. Place the grommets on the screws. Insert the screws

through the holes in the metal tabs on the ends of the

belt sections. Reinsert the screws into the screw holes

and screw holes and secure them to the seat frame.

APPLICATION

29 Wells Avenue

Yonkers, NY 10701

Closure

SIDE-RELEASE BUCKLE

SIDE-RELEASE BUCKLE

RESIDENT-FRIENDLY BUCKLE

VELCRO

VELCRO

VELCRO W/RED LOOP

-OVER-

914-963-2040

800-431-2972

Size

42"L x 2"W

54"L x 2"W

42"L x 2"W

37"L x 2"W

60"L x 2"W

37"L x 2"W