Honeywell Limitless WLS Series Quick Start Manual

Quick Start Guide for the

Limitless™ WLS Series Single Switch Adapter

Used in conjunction with the Limitless™ WPMM or WDRR Series

m WARNING

PERSONAL INJURY

DO NOT USE these products as safety or emergency stop

devices or in any other application where failure of the product

could result in personal injury.

Failure to comply with these instructions could result in

death or serious injury.

m WARNING

Honeywell does not recommend using devices for critical

control applications where there is, or may be, a single point of

failure or where single points of failure may result in an unsafe

condition. It is up to the end-user to weigh the risks and benefits

to determine if the products are appropriate for the application

based on security, safety and performance. Additionally, it is

up to the end-user to ensure that the control strategy results in

a safe operating condition if any crucial segment of the control

solution fails. Honeywell customers assume full responsibility

for learning and meeting the required Declaration of Conformity,

Regulations, Guidelines, etc. for each country in their distribution

market.

Sensing and Control

m WARNING

RF EXPOSURE

To satisfy FCC RF exposure requirements for mobile transmitting

devices, a separation distance of 20 cm or more should be

maintained between the antenna of this device and persons

during device operation To ensure compliance, operation at

closer than this distance is not recommended. The antenna

used for this transmission must not be co-located in conjunction

with any other antenna or transmitter.

Failure to comply with these instructions could result in

death or serious injury.

m WARNING

The WLS Single Switch Adapter must be installed in accordance

with the requirements specified in this document in order to

comply with the specific Country Communication Agency

requirements (i.e., FCC, IC, ETSI, ACMA, etc.). See Section 3 of

the Installation and Technical Manual as this requires choosing

the correct Country Use Code and thus allowable antenna and/

or cable usage.

CAUTION

Power to the WLS Single Switch Adapter should not be applied

(ensure battery is removed) during installation of antenna

as damage could occur to the WLS Single Switch Adapter

electronics.

Issue 1

50081314