Emerson Appleton Areamaster GEN 2 LED Series Instruction Sheet

Installation Instructions for Appleton™ Areamaster™ GEN 2 LED Luminaire -

Yoke Mount

FOR PROPER AND SAFE INSTALLATION OF THIS PRODUCT, PLEASE READ THE FOLLOWING INSTRUCTIONS.

Product Safety

Signal Words Defined

DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING indicates a hazardous

situation which, if not avoided, could result in death or serious injury. CAUTION indicates a hazardous situation which, if not avoided,

could result in minor or moderate injury. NOTICE is used to address practices not related to physical injury.

Safety Instructions

WARNING:

• Do not open or remove luminaire with the circuit energized.

• Do not remove or replace fuse when luminaire is energized.

• Do not use this luminaire on ungrounded systems. Failure to ground this luminaire can result in an electric shock, which may be fatal.

• Do not use on ungrounded 480 Volt circuits.

CAUTION:

• Do not look directly at the LEDs when energized.

NOTICE:

• Do not touch the LEDs; touching could leave oily deposits, causing hot spots and potential premature failure.

• This product must be installed in accordance with the applicable installation code by a person familiar with the construction and

operation of the product and the hazards involved.

• This luminaire is designed for and should be installed in accordance with the National Electrical Code

and all applicable local codes.

Marine & Hazardous Locations

CAUTION/ATTENTION:

• To reduce the risk of ignition of hazardous atmospheres, disconnect the luminaire from the supply circuit before opening. Keep

tightly closed when in operation.

Pour réduire le risque d'inflammation/explosion en atmosphères explosibles, isoler le luminaire du circuit d'alimentation avant

ouverture. Veillez à ce que le luminaire soit correctement fermé avant la mise sous tension.

• Make sure to tighten unused close-up plug to 400 in.-lb. after applying TLNC4 grease. TLNC4 grease shall be applied in 3 lines,

spaced approximately 120 degrees apart, perpendicular to the threads.

• Where flexible cord is used, it should be approved for extra hard, wet location usage and shall have a separate ground conductor.

Agency Ratings: (NEC/CEC)

• Class I, Division 2, Groups A, B, C, & D

• Class II, Division 1, Groups E, F, & G

• Class II, Division 2, Groups F & G

• Class III

• Simultaneous Exposure

• Class I, Zone 2, Group IIC

Appleton • 1.800.621.1506 • www.appletonelec.com

650525-001 INSTRUCTION SHEET

• Zone 20, Group IIIC

• Zone 21, Group IIIC

• Zone 22, Group IIIB

• Wet Locations

• Marine Outside Type (Salt Water) (For installation in USA only)

• Type 3R, 4, & 4X

• IP66 & IP67

/Canadian Electrical Code

®

650525-001 Rev. B 10/16 • Page 1 of 1