Fujitsu ASTG18KMCA Technical Manual page 31

Wall mounted type
Hide thumbs Also See for ASTG18KMCA:
Table of Contents
Use the following steps to select the custom code of the remote controller. (Note that
the air conditioner cannot receive a custom if the right custom code has not been set.)
(1) Press the START/STOP ( / ) button until only the clock is displayed on the
remote controller display.
(2) Press the MODE button for at least 5 seconds to display the current custom code
(initially set to ).
(3) Press the SET TEMP. (
→ .
Match the code on the display to the air conditioner custom code.
(4) Press the MODE button again to return to the clock display. The custom code will
be changed.
If no button is pressed within 30 seconds after the custom code is displayed, the system returns to the original
clock display. In this case, start again from step (1).
The air conditioner custom code is set to A prior to shipment.
) buttons to change the custom code between
- (01 - 28) -
Table of Contents

This manual is also suitable for:


Table of Contents