Makita AF635 Instruction Manual

Makita AF635 Instruction Manual

Pneumatic finish nailer
Hide thumbs Also See for AF635:

Quick Links

INSTRUCTION MANUAL
Pneumatic Finish Nailer
AF635
Read before use.
Table of Contents
loading

Summary of Contents for Makita AF635

  • Page 1 INSTRUCTION MANUAL Pneumatic Finish Nailer AF635 Read before use.
  • Page 2: Specifications

    SPECIFICATIONS Model: AF635 Air pressure 0.49 - 0.83 MPa (4.9 - 8.3 bar) Nail length 32 mm - 64 mm Nail capacity 100 pcs. Minimum hose diameter 6.5 mm Pneumatic tool oil ISO VG32 or equivalent Dimensions (L x W x H)
  • Page 3 Handle the tool carefully, as there is high pres- Safety devices sure inside the tool that can be dangerous if a Make sure all safety systems are in working crack is caused by rough handling (dropping order before operation. The tool must not oper- or striking).
  • Page 4: Installation

    Keep the tool in tip-top condi- tion. Lubricate moving parts to prevent rusting and minimize friction-related wear. Wipe off all dust from the parts. Ask Makita authorized service center for peri- odical inspection of the tool. To maintain product SAFETY and RELIABILITY, maintenance and repairs should be performed by Makita Authorized Service Centers, always using Makita replacement parts.
  • Page 5: Functional Description

    Use an air hose as large and as short as possible to FUNCTIONAL assure continuous, efficient nailing operation. DESCRIPTION With an air pressure of 0.49 MPa (4.9 bar), an air hose with an internal diameter of over 6.5 mm and a length of less than 20 m is recommended when the interval between each nailing is 0.5 seconds. CAUTION: Before adjusting or checking Air supply hoses shall have a minimum working pres-...
  • Page 6 Air duster CAUTION: Do not aim the ejection port of the air duster to someone. Also, keep your hands and foot away from the ejection port. If the air duster button is accidentally pushed, it may cause a per- sonal injury. CAUTION: Always check your surroundings before using the air duster. Blown dust or objects may hit someone.
  • Page 7: Selecting The Operation Mode

    OPERATION CAUTION: Make sure all safety systems are in working order before operation. Selecting the operation mode CAUTION: Always make sure that the actua- tion mode selector is properly set to the position for the desired nailing mode before nailing. ► 1 .
  • Page 8: Maintenance

    MAINTENANCE CAUTION: Do not place the contact element against the workpiece with excessive force. Also, pull the trigger fully and hold it on for 1-2 seconds CAUTION: Before attempting to perform after nailing. inspection or maintenance, always return the trig- Even in the “Single sequential actuation” mode, half- ger and disconnect the air hose from the tool.
  • Page 9: Optional Accessories

    OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service ► 1 .
  • Page 12 Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan AF635-ENAU-1604 www.makita.com 20160624...

Table of Contents