Quick Links

CNI4
CNI4 Quick Start Guide
FD-601 | Version 1 | September 2017
Honeywell Process Solutions | Mercury Instruments
512 Virginia Drive Ft. Washington PA 19034 USA
855 251-7065 – United States & Canada
|
302 669-4253 – Outside the United States
| www.honeywellprocess.com
loading

Summary of Contents for Honeywell CNI4

  • Page 1 CNI4 CNI4 Quick Start Guide FD-601 | Version 1 | September 2017 Honeywell Process Solutions | Mercury Instruments 512 Virginia Drive Ft. Washington PA 19034 USA 855 251-7065 – United States & Canada 302 669-4253 – Outside the United States [email protected]...
  • Page 2 Step 8: Close and lock the door. Step 1: Open the door of the CNI4 and install the SIM Card 1. Lift the SIM card cover on the Cloud Link. 2. Slide the white SIM card holder to the right, then lift the left edge.
  • Page 3 Step 2: Power-up the CNI4 - battery or external power supply To connect the battery packs to the Cloud Link 4G Modem 1. Install the Cloud Link battery packs with positive terminal on top. 2. Tie wrap the batteries to the metal plate.
  • Page 4 1. Remove the housing on the cable gland and route the pulse input(s) cable through it. 2. Unplug the male 4-pin terminal block connector. 3. Connect the external input pulse wires of the cable into appropriate slot on the 4- pin terminal block connector. 4. Reconnect the 4-pin terminal block connector. CNI4 Quick Start Guide...
  • Page 5 3. Launch and login to the MasterLink desktop application. 4. Navigate to the Settings menu, set the baud rate to the recommended value (9600), and click OK. 5. Click Connect to connect to the Pulse Accumulator. CNI4 Quick Start Guide...
  • Page 6 Modem Retry Interval B 1440 minutes Modem Retry A Count 10. Click Disconnect to disconnect MasterLink from the Pulse Accumulator. The following message is displayed upon a successful disconnection from the Pulse Accumulator. Close the pop-up. CNI4 Quick Start Guide...
  • Page 7 4. Close the warning pop-up, enter site name, and click Save. 5. Wait for the dashboard to load. Click the center of the Time Sync widget and perform a time synchronization between the Cloud Link and the PC by clicking Sync. CNI4 Quick Start Guide...
  • Page 8 Modem session timeout 180 seconds 8. Disconnect MasterLink. 9. Power cycle the CNI4. Step 7: Restore the original serial cable connection 1. Disconnect the USB to serial cable (40-6147-kit). 2. Restore the original serial interface between the Pulse Accumulator and the Cloud Link 4G Modem.