S&P PCRL80 Manual

Model: PCRL80

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

a). Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.

b). Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent

power from being switching on accidentally. When the service disconnecting means cannot be locked, securely fasten a

prominent warning device, such as a tag, to the service panel.

c). Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and

standards, including fire-rated construction codes and standards.

d). Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning

equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as

those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE), and the local code authorities.

e). When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

f). Ducted fans must always be vented to the outdoors.

g). Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch

circuit (ceiling installation only).

h). This unit must be grounded.

i). Not for Use in Kitchens.

j). Install Fan At Least 2.5 m (8.2 feet) Above The Floor.

k). To reduce risk of fire and to properly exhaust air, be sure to duct air outside – Do not vent exhaust air into spaces

within walls or ceilings or into attics, crawl spaces, or garages

l). WARNING: To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control

Device.

m). The fan must not be installed in a ceiling thermally insulated to a value greater R40.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

2. This product is designed for installation in ceilings up to a 12/12 pitch (45 degree angle). Duct connector must be horrizontal.

* DO NOT MOUNT THIS PRODUCT IN A WALL.

3. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off

power unit.

4. Please read specification label on product for further information and requirements.

CLEANING & MAINTENANCE

For quiet and efficient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit with

the dusting brush attachment.

The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or unusual noises,

replace the motor with the exact service motor. The impeller should also be replaced.

OPERATION

Use a 2-function wall control to operate this fan. See "Connect Wiring" for details.

PLAN THE INSTALLATION

1. Do not use in a cooking area.

2. Two ways to connect ductwork to a factory-shipped unit.

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner.

PCRL80F

RECESSED FAN LIGHT

INSULATION*

(Place around and

over Fan Housing.)

FAN

POWER

HOUSING

CABLE*

Seal gaps

around

Housing.

ROUND

DUCT*

Seal duct

*

Purchase

ROUND

joints with

ELBOW(S) *

separately

tape.

ROOF CAP*

(with built-in

damper)

Keep duct

runs short

WALL CAP*

(with built-in

damper)