Fujitsu LifeBook S-61 Series Service Manual

Disassembly procedure

Quick Links

LifeBook S-61xx
Disassembly Procedure
1. To begin the disassembly proce-
dure, make sure the unit is powered
off. Remove the battery.
3. Remove two screws securing the
memory module cover. Lift off the
cover, unlock the module, and
remove it.
T e c h n i c a l
2. Slide the CD/DVD drive out from
its bay.
4. Remove two screws securing the
cover to the hard disk drive. Detach
the drive's data cable and lift it out
of its compartment.
P r o c e d u r e
loading

Summary of Contents for Fujitsu LifeBook S-61 Series

  • Page 1 T e c h n i c a l P r o c e d u r e LifeBook S-61xx Disassembly Procedure 1. To begin the disassembly proce- 2. Slide the CD/DVD drive out from dure, make sure the unit is powered its bay.
  • Page 2 6. Pry jup the hinge cover. Unlock and remove the cable to the status 5. Remove a total of 14 case screws. LCD. 8. Tilt up the keyboard so as to 7. Detach the speakers’ cable and lift unlock and remove its data cable. off the cover.
  • Page 3 12. Remove two hinge screws at the upper corners. Lift off the LCD. 11. Remove two hinge screws at at the rear. 14. Unlock and release the touchpad 13. Remove seven screws securing cable. the top cover. 16. Remove four screws securing the 15.
  • Page 4 17. Remove two hex nuts on either side of the VGA port. Lift off 18. Then lift off the connecting board. the heat sink. 20. Maneuver the motherboard out of the lower cover. 19. Lift off the modem cable and port. 22.
  • Page 5 23. Pry around the edges of the frame to separate it from the rear cover. 24. Remove two screws securing the locking clip and two at the lower corners. 25. Lift up the LCD panel to access and detach its cable to the invert- 26.
  • Page 6: Assembly Procedure

    T e c h n i c a l P r o c e d u r e LifeBook S-61xx Assembly Procedure 1. Replace the antennae and secure it. 2. Position the inverter in the rear Attach its cable. cover. Attach the LCD’s cable to the inverter and then tilt the panel into the cover.
  • Page 7 5. Connect the cooling fan’s power 6. Maneuver the motherboard into the cable. Turn the board over and lower cover. secure the fan with two screws. 7. Position the modem port and cable. 8. Position the connecting board in the lower cover. 10.
  • Page 8 11. Press the upper cover onto the 12. Insert and lock the touchpad assembly. Secure the cover with cable. seven screws. 13. Position the LCD onto the lower 14. Connect the LCD’s data and assembly. Secure the hinges with power cables. two screws at the top and two at the rear.
  • Page 9 17. Position the hinge cover. so that you can insert and lock the cable 18. Connect the speakers’ cable. Press to the status LCD. the cover securely into place. 20. Place the hard disk drive into its compartment and connect its data 19.
  • Page 10 23. Lower the battery into its com- partment and press to lock it.