Honeywell 46190153-501 Manual

Carriage motor kit

Quick Links

CARRIAGE MOTOR KIT
46190153-501
DPR180
EN
CK 196
Issue : 1
(10/96)
loading

Summary of Contents for Honeywell 46190153-501

  • Page 1 CARRIAGE MOTOR KIT 46190153-501 DPR180 CK 196 Issue : 1 (10/96)
  • Page 3 1. Please use an antistatic ground strap to avoid possible electrostatic damage to the printed circuit boards. 2. Isolate the recorder from the mains supply. 3. Open the recorder door and remove the chart cassette from the chassis. 4. Turn OFF the switch (See fig. 1). Recorder mains powerswitch - Located behind the chart cassette Figure 1 5.
  • Page 4 Figure 2...
  • Page 5 12. Remove all the terminal blocks (See fig. 3). (1) Press down on the terminal block clips. (2) Pull to release the terminal block. Figure 3 13. Remove all the grommets (See ref. A, fig. 4). 14. Unscrew the 4 fixing screws (M4) from the chassis with the Torx key T20 (See ref. B, fig. 4). 15.
  • Page 6 17. Disconnect the carriage drive motor (See fig. 5). WARNING: Make a note of correct polarity of the connector prior to removal. View from the rear of the recorder. Figure 5 18. Pass the carriage motor connector cable through the hole located at bottom of the printer chassis. Figure 6 19.
  • Page 7 Figure 7 21. Fit the new carriage motor but do not tighten the fixing screws. 22. Pass the motor cable through the hole at the bottom of the printer chassis (Reconnect the motor connector to the backplane board). Ensure correct polarity of the plug. 23.
  • Page 8 25. Move the printer carriage fully to the left hand side (See fig. 9). Figure 9 26. Measure the drive belt tension with a dynamometer and adjust the belt tension by moving the carriage motor (See ref. A, fig. 10). 27.
  • Page 9 29. Slide the recorder chassis back into the outer case. 30. Refit the 4 fixing screws (M4) with the Torx key T20 (See ref. B, fig. 4). 31. Refit all the input/output boards. 32. Refit all the terminal blocks in the correct locations and then refit alll the grommets (See fig. 11). 33.
  • Page 10 Positions AI = Analog input From A to F (Lower rack) AO = Auxiliary output From N to P (Upper rack) DI = Digital input From J to P (Upper rack) DO = Digital output (relay) From J to P (Upper rack) Figure 11...