Sony BKNW-116 Installation Manual

Disk unit
Hide thumbs Also See for BKNW-116:

Quick Links

DISK UNIT
BKNW-116
INSTALLATION MANUAL
1st Edition
Serial No. 10001 and Higher (SY)
Serial No. 30001 and Higher (J)
Table of Contents
loading

Summary of Contents for Sony BKNW-116

  • Page 1 DISK UNIT BKNW-116 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher (SY) Serial No. 30001 and Higher (J)
  • Page 2 ! WARNING This manual is intended for qualified service personnel only. To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel.
  • Page 3: Table Of Contents

    Rack Mounting ..................1-4(E) 1-7. How to Connect Hybrid Recorder ............1-8(E) 1-7-1. Connection ................1-8(E) 1-7-2. Setting of Hybrid Recorder ........... 1-8(E) 2. Service Overview 2-1. Signal Inputs and Outputs ..............2-1(E) 2-2. Filter Cleaning ..................2-2(E) 1 (E) BKNW-116...
  • Page 4: Manual Structure

    Manual Structure Purpose of this manual This manual is the installation manual of hard disk unit BKNW-116. This manual is intended for use by trained system and service engineer, and provides the informa- tion that is required to install. Contents This manual is organized by following sections.
  • Page 5: Caution For Handling The Unit With Built-In Hdd

    If there is something wrong with the HDD of this unit (a failure occurs in the HDD), handle this unit in the same manner as described above. This protects the HDD from increace of the damage till confirming the contents of the failure or analyzing the failure. 3 (E) BKNW-116...
  • Page 7: Installation

    Unpacking When the unit is transported, it is required to pack the unit into the specified new packing materials. Do not reuse the packing materials Rack mounting 1-6. Rack Mounting Connection 1-7. How to Connect Hybrid Recorder 1-1 (E) BKNW-116...
  • Page 8: Operating Conditions

    . Dusty areas or areas subject to vibration. 2 Plug holder (brown) . Areas with strong magnetic field. 3-613-640-01 Contact your local Sony Sales Office/Service Center. . Areas with much electrical noise. . Areas with much static electricity. AC inlet .
  • Page 9: Installation Space

    If the ventilation is not enough, the unit may be damaged because an increase of the internal temperature of the unit can not reduce. Mass: 23 kg Air flows Rear side Front side DISK UNIT BKNW-116 POWER BUSY WARM-UP ALARM (1234) When pulling out rack mount Unit: mm 1-3 (E)
  • Page 10: Rack Mounting

    N.m{10 kgf.cm} . Plate nuts (small) . Screws (PSW4 x 16) . Screws (B4 x 8) . Hexagon socket head cap screws . Flat washers . Screws (RK5 x 14) . Ornamental washers . L-shaped hexagon wrench 1-4 (E) BKNW-116...
  • Page 11 Rack angle PSW4 x 16 (3). Tightening torque: 120 x 10 N.m{12.2 kgf.cm} Inner rail Rack angle B4 x 6 Inner rail B4 x 6 1-5 (E) BKNW-116...
  • Page 12 Tightening torque: 120 x 10 N.m{12.2 kgf.cm} Outer rail Rack Plate nut (large) Rail bracket Outer rail Intermediate rail Ball retainer Intermediate rail 50 to 55 mm B4 x 8 B4 x 8 Rack angle 1-6 (E) BKNW-116...
  • Page 13 Tightening torque: 120 x 10 N.m{12.2 kgf.cm} (1) Stagger the ball retainers of intermediate rails on both sides (left and right) toward you. Ornamental washer RK5 x 14 Intermediate rail Ball retainer Ornamental RK5 x 14 washer 1-7 (E) BKNW-116...
  • Page 14: How To Connect Hybrid Recorder

    (Supplied with this unit) If the way of setting is not described in your operation SCSI terminal connector: 1-774-818-11 manual, contact your local Sony Sales Office/Service (Supplied with hybrid recorder) Center. Use the specified cable and connector. If not, the operation may become unstable.
  • Page 15: Service Overview

    SCSI REQ (_) SCSI I/O (+) SCSI I/O (_) SCSI GND SCSI GND (_) SCSI DB8 (+) SCSI DB8 (_) SCSI DB9 (+) SCSI DB9 (_) SCSI DB10 (+) SCSI DB10 (_) SCSI DB11 (+) SCSI DB11 (_) 2-1 (E) BKNW-116...
  • Page 16: Filter Cleaning

    Be sure to remove the filter from the front panel before cleaning. B3 x 5 4. Attach the filter to the front panel. 5. Install the front panel. B3 x 5 Front panel 2-2 (E) BKNW-116...
  • Page 17 The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...
  • Page 18 Printed in Japan Sony Corporation BKNW-116 (J, SY) J, E 1999. 1 08 3-862-492-01 (2) Broadcasting & Professional Systems Company ©1998...

Table of Contents