Sealey ES200 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly

maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.

USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE

DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

! WARNING! Before use, ensure that the vehicle handbrake is on and that you have safe access to the underside of the vehicle.

! WARNING! Before use, ensure that the cross member on the underside of the vehicle to which you will mount the engine support

is structurally sound and undamaged. Do not proceed if you are doubtful about the condition of the mounting area.

Maintain the engine support in good condition (use an authorised service agent).

"

Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.

"

Ensure that there is adequate lighting.

"

DO NOT attempt to modify another adaptor to fit.

#

# DO NOT use the engine support if damaged.

DO NOT make any modifications to the engine support.

#

# DO NOT operate the engine support when you are tired or

under the influence of alcohol, drugs or intoxicating medication.

# DO NOT use the engine support for a task it is not designed to perform.

# DO NOT allow untrained persons to operate the engine support.

DO NOT attempt to use an adaptor that does not fit properly.

#

Ensure that the floor beneath is not slippery and wear non-slip shoes.

"

Keep children and unauthorised persons away from the work area.

"

2. INTRODUCTION & APPLICATIONS

The ES200 together with its associated adaptors supports or raises the engine from underneath during maintenance operations without the use

of a trolley jack or conventional over-engine support beam. It allows unimpeded access to the engine from above and also permits safe

movement of the vehicle whilst the engine is raised. Vehicle specific adaptor sleeves mount onto the vehicle structure and the base unit is then

attached to the sleeve. The engine is raised by a screw adjusted pad. The unit is ideal for rapid and safe cambelt changes, engine mount

replacement, transmission removal, etc. The adaptor sleeves shown below are not supplied with the base unit and must be ordered separately.

ES200-01

FORD GALAXY, SEAT ALHAMBRA,

VW SHARAN

ES200-04

PEUGEOT 206, 307

ES200-07

FORD FUSION, FIESTA

INSTRUCTIONS FOR MODEL:

UNDER VEHICLE ENGINE SUPPORT

+ ADAPTORS

ES200 BASE UNIT with locking pin

and two-part end clamp.

(Adaptors must be ordered

separately from the base unit.)

ES200-02

AUDI A3, SEAT LEON, SKODA OCTAVIA,

VW GOLF 4, BEETLE

ES200-05

CITROEN BERLINGO,

PEUGEOT 406, PARTNER

ES200-08

AUDI A3, SEAT ALTEA, TOLEDO,

SKODA OCTAVIA 2004, VW GOLF 5

ES200

ES200-03

FORD FOCUS

ES200-06

FORD C-MAX

ES200-10

VW LUPO

ES200, ES200-01 to 29 - 3 - 220207