Quick Links
Related Manuals for Sony CBK-SD01
Summary of Contents for Sony CBK-SD01
- Page 1 SDI OUTPUT BOARD CBK-SD01 INSTALLATION MANUAL 1st Edition...
- Page 2 Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. CBK-SD01...
-
Page 3: Table Of Contents
Applicable Models for Installation ............1-1 (E) 1-3. Installation Procedure ................1-1 (E) 1-4. Opening and Closing the Inside Panel ..........1-2 (E) 1-5. Installing the CBK-SD01 (DIF-147 Board) .......... 1-3 (E) 1-6. Select Output Signal ................1-5 (E) CBK-SD01... -
Page 5: Installation
. PDW-510/510P/530/530P . MSW-900/900P 1-3. Installation Procedure Outline of the installing the CBK-SD01 to the PDW-510/510P/530/530P, MSW-900/900P is listed as follows. For the details of the installation work, refer to the respective sections. Installation procedure Sections describing the detailed procedure 1. -
Page 6: Opening And Closing The Inside Panel
Be very careful when handling the flexible card wire not to fold it. . To install CBK-SD01 in MSW-900/900P, place the unit so that the inside panel is positioned on top of the POWER switch when the inside panel is opened. -
Page 7: Installing The Cbk-Sd01 (Dif-147 Board)
1-5. Installing the CBK-SD01 (DIF-147 Closing the Inside Panel Board) 1. Confirm that both of the right and left hinges are engaged with the hooks of the chassis correctly. 1. Disconnect the coaxial cable form the connector 2. Attach the inside panel and fix it with the four screws (CN10) on the DCP-36 board (the DCP-32 board for (with drop-safe). - Page 8 2. Insert the connector (CN2) of the CBK-SD01 (DIF- 147 board) to the connector (CN2) on the DCP-36 board (the DCP-32 board for MSW-900/900P) and fix it to the supports with the two screws supplied. Standard tightening torque value : Screw P1.4 x 3.5...
-
Page 9: Select Output Signal
3. Select the OPERATION menu and press the rotary encoder. 4. Select the OUTPUT display and press the rotary encoder. 5. Move the cursor (→) to REAR BNC SEL and press the rotary encoder to select SDI. 6. Turn off the main power. 1-5 (E) CBK-SD01... - Page 11 The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.
- Page 12 Printed in Japan Sony Corporation CBK-SD01 (SY) J, E 2004. 1 16 B&P Company 3-797-090-01 ©2004...