Quick Links
INSTALLATION MANUAL
NETWORK CONVERTOR
For authorized service personnel only.
安装说明书
网络转换器
只适用于专业维修人员
MANUEL D'INSTALLATION
ADAPTATEUR RESEAU
Uniquement réservé aux techniciens agréés.
MANUAL DE INSTALACIÓN
CONVERTIDOR DE RED
Sólo para personal de mantenimiento autorizado.
MANUAL DE INSTALAÇÃO
UTY-VLGX
CONVERSOR DE REDE
Apenas para técnicos de assistência autorizados.
PART NO. 9708436029
Related Manuals for Fujitsu Airstage UTY-VLGX
Summary of Contents for Fujitsu Airstage UTY-VLGX
- Page 1 INSTALLATION MANUAL NETWORK CONVERTOR For authorized service personnel only. 安装说明书 网络转换器 只适用于专业维修人员 MANUEL D’INSTALLATION ADAPTATEUR RESEAU Uniquement réservé aux techniciens agréés. MANUAL DE INSTALACIÓN CONVERTIDOR DE RED Sólo para personal de mantenimiento autorizado. MANUAL DE INSTALAÇÃO UTY-VLGX CONVERSOR DE REDE Apenas para técnicos de assistência autorizados.
-
Page 2: Table Of Contents
INSTALLATION MANUAL ▪ Area that generates substances that adversely affect the equipment, such as sulfuric gas, chlorine gas, acid, or PART NO. 9708436029 alkali. It will cause the copper pipes and brazed joints to NETWORK CONVERTOR corrode, which can cause refrigerant leakage. Contents ▪... -
Page 3: Electrical Requirement
Screw (M4 x 20 mm) Operating 0–46 (32–114) Temperature For mounting the Network °C(°F) Convertor. Packaged -10–60 (14–140) Humidity (%) Packaged 0–95 (RH); No condensation Dimensions 67 x 288 x 211 (2-5/8 x 11- CD-ROM For initial setting. H x W x D mm(in1) 11/32 x 8-5/16) Weight g (oz1) 1500 (53) -
Page 4: Wiring Method
Note : Confirm the name of each unit and name of each terminal Router should be needed by the number of block of the unit and connect the wiring in accordance controlling items in the BMS. with the directions given in the manual so that there is no *1. -
Page 5: Installing The Network Convertor
Make a hole in the center of the dust proof bush- INSTALLING THE NETWORK CONVERTOR ing with the Phillips head screwdriver. Pass the power supply cable through the hole WARNING of dust proof bushing and pull it into the network convertor. -
Page 6: Turning On The Power
ADDRESS SETTING Tightening torque for installing cables to terminal block ▪ Setting up more than 1 Network Convertor in 1 VRF net- 0.8 to 1.2 N • m (7.1 to 10.6 lbf • in) work system is prohibited. ▪ When setting address, please be sure that the address of Network Convertor is not overlap the address of other TURNING ON THE POWER controller like, Touch Panel Controller &... -
Page 7: Initial Setting (Software)
LED DISPLAY (D19) Turn the power off and on or press SW7 (reset button) to exit from address setting mode. (1) Normal code This time, please refer to the “7. TURNING ON THE POWER” for the content displayed in D19 LED. Normal code Contents Normal mode...