Sony BKP-7311 Installation Manual

Sdi output board

Quick Links

SDI OUTPUT BOARD
BKP-7311
INSTALLATION MANUAL
1st Edition
loading

Summary of Contents for Sony BKP-7311

  • Page 1 SDI OUTPUT BOARD BKP-7311 INSTALLATION MANUAL 1st Edition...
  • Page 2 électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. BKP-7311 IM...
  • Page 3: Table Of Contents

    1-3................1-2 (J) 1-4..................1-5 (J) 1. Installation 1-1. General ....................1-1 (E) 1-2. Function of Switches on AD Board ............1-1 (E) 1-3. Installation of BKP-7311 ..............1-2 (E) 1-4. System Adjustment ................1-5 (E) BKP-7311 IM...
  • Page 5: Installation

    1-1. General . S2963 (REMOTE ON/OFF) Selects an output signal at SERIAL OUTPUT connector BKP-7311 is the board kit that has a function of color of CCU. corrector and D1 format serial digital output. When this : Outputs test signal which is selected by S2962...
  • Page 6: Installation Of Bkp-7311

    1-3. Installation of BKP-7311 1-3. Installation of BKP-7311 1. Disconnect the power cord from the rear panel of 4. Remove the six screws (B3 x 5) and open the rear CCU-700A. Loosen the two screws (M4 x 20) and panel. Disconnect the flexible card wire from CN3 on remove the front panel.
  • Page 7 1-3. Installation of BKP-7311 6. Hook the harness guide onto the rail plate and push it 9. Extract the three coaxial cables from the front side in the direction of the arrow. about 150 mm as shown in the figure.
  • Page 8 Lock Plug-in boards 13. Install the power unit in the unit with four screws. 15. Insert the BKP-7311 in the unit,and connect the three coaxial cables to the BKP-7311. The same signal is output at connectors CN2571, Power unit CN2572 and CN2581.
  • Page 9: System Adjustment

    1-3. Installation of BKP-7311 1-4. System Adjustment 1-4. System Adjustment 16. Tighten the two screws (M4 x 20) on the front panel to install the front panel. Perform the adjustment of VA-156A board in CCU-700A (VA-156P board in CCU-700AP) as follows.
  • Page 11 The material contained in this manual consists of information that is the property of Sony Corporation and is intended solely for use by the purchasers of the equipment described in this manual. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any...
  • Page 12 Printed in Japan Sony Corporation BKP-7311 (SY) J, E 2002. 3 08 B&P Company 3-619-325-01 ©2002...