HP F1798 Installation Instructions

BatteryShip.com

F1798 HP Jornada 520, 525 Series Battery Installation Instructions

PLEASE NOTE: Patience and care, along with moderate technical and hand tool ability, are required for the successful

replacement of a PDA battery. Excessive force may result in damage to your PDA. The instructions below come with

no warranty or guarantee. By utilizing these instructions, you agree to hold Batteryship.com blameless and unaccountable

for any and all damages, problems, or personal injuries that may or may not arise by your use of these instructions.

Replacing your Jornada battery may void any warranty you have on your Jornada. Please read all instructions and

back up your data BEFORE replacing the battery.

Included Phillips Screwdriver

Step 1.

Remove the four screws on the back of the PDA using the included

Phillips screwdriver. Set the screws aside for reassembly.

Step 3.

Remove your old battery from its seat, using the enclosed plastic

flathead screwdriver to assist (as shown) if necessary. Leave the

connector plugged in for this step. The battery may be glued in,

so pry under it GENTLY until it comes loose. Take care not to break

the old battery while removing it.

(Steps 5 & 6 continued on back)

Included Plastic Flathead Screwdriver

Step 2.

Once the screws have been removed, GENTLY

pry open the Jornada case (starting at the top, as

shown) using the included plastic screwdriver. Pry

around the device until the back cover comes open

completely.

Step 4.

Disconnect the old battery at the connector by

CAREFULLY pulling outward on the connector

with your thumb and forefinger or tweezers. Be

very sure that you are pulling outward on only the

part of the connector that comes out, as shown,

NOT on the whole connector.