Honeywell 290091.2 Manual

Installation / installasjon / installation:

UniLED

ProLED

The device comes with 4 label stickers that contain a Unique identification code (UID) that is

GB

hexadecimal formatted in 4 bytes. An example UID is 45 90 DB FA. It is advised to stick one sticker

on the module and one sticker on the luminary that the module will be fitted in. The two remaining

stickers may be placed on a printed floor plan, text lists etc.

-

Disconnect mains. Refer to the luminaire installation manual for disassembly.

-

Disconnect the battery. Carefully insert wireless module as shown in picture above.

-

Reconnect the battery and observe the module's LEDs for proper operation. Assemble the luminaire.

-

Reconnect mains. You are now ready to setup the module for network communication. For the network

setup refer to the wireless network commissioning manual.

Function

This device has three indication LEDs.

Top LED (green): RF connection status

Steady on:

Flashing 5 times per sec.:

Flashing 2 times per sec.:

Flashing 1 sec. on / 1 sec. off: The device has established connection to a single Router Device, and no

No light:

Middle LED (green): Received signal strength (RSSI)

Flashing 5 times per sec.:

Flashing 2 times per sec.:

Flashing 1 sec. on / 1 sec. off: RSSI is acceptable for reliable communication.

Flashing 2 sec. on / 2 sec. off: RSSI is not acceptable for reliable communication.

Bottom LED (red): Indicates initialization

Flashing 5 times per sec.:

Flashing 2 times per sec.:

Button functionality

Short press:

Press more than 2 sec.:

Honeywell Life Safety AS, Po. Box 3514, N-3007 Drammen, Norway

Wireless

Module

OvaLED/OmniLED Spot

AgoraLED

The device has established direct connection to a Gateway Device, and at least

one more Gateway Device is available for alternate routing (false condition).

The device has established direct connection to a single Gateway Device.

The device has established connection to a Router Device, and at least one

more Router Device is available on the same hop level, as an alternate route

(redundant connection).

alternatives exist on the same hop level.

The device is disconnected.

RSSI is very good.

RSSI is good.

The module is not initialized correctly. In this case you have to press for more

than 2 seconds the push button, in order to re-initialize the module.

The module is working properly.

A status message will be issued to the gateway device of the wireless network.

The router module will restore to its factory default settings. This is extremely

useful in case of an error setting during wireless network installation.

part no. 290091.2

OvaLED/OmniLED/AeriLED

http://www.hls-nordic.com