Replacement Of Devices - Bosch Rexroth IndraDrive CsDrive System with HCS01 Project Planning Manual
Hide thumbs
Also See for Rexroth IndraDrive CsDrive System with HCS01:
- Instruction manual (68 pages)
Table of Contents
DOK-INDRV*-HCS01******-PR05-EN-P
Rexroth IndraDrive CsDrive Systems with HCS01
Looping through the voltage
Replacement of devices
3.6 V
Direct voltage source (battery or UPS)
A
Shielded lines, e.g. (2x0,5)C; connect cable shield to
connection
B
Twisted single wires
Fig. 8-27:
Looping through the voltage
When replacing an HCS01, observe the following aspect:
Leave the 4-pin spring terminal with the connected battery/UPS at the D-Sub
connector so that voltage is still applied and the encoder position is retained.
Bosch Rexroth AG
Cables, accessories, additional components
at top of device
273/341
shield
- Quick Links:
- Hap01 Control Panel
Hide quick links:
Table of Contents
