Panasonic ET-PNT100 Operating Instructions

Names

Rod

Infrared Emitter

Bofore using the pointer

Screw the long rod into the body of the pointer

until it is secure. Install batteries.

How to use the pointer

While pressing the button, when the LED lights,

the infrared ray at the end of the rod also lights.

This is sensed by the infrared ray sensor on the

front of the projector, and the location of the tip of

the pen is detected.

1) Press the power button to turn the power on.

2) Place the tip of the pointer anywhere on the

screen.

Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)

This symbol on the products and/or accompanying documents means that used electrical and

electronic products should not be mixed with general household waste. For proper treatment,

recovery and recycling, please take these products to designated collection points, where

they will be accepted on a free of charge basis.

Alternatively, in some countries you may be able to return your products to your local retailer

upon the purchase of an equivalent new product.

Disposing of this product correctly will help to save valuable resources and prevent any

potential negative effects on human health and the environment which could otherwise arise

from inappropriate waste handling. Please contact your local authority for further details of

your nearest designated collection point.

Penalties may be applicable for incorrect disposal of this waste, in accordance with national

legislation.

For business users in the European Union

If you wish to discard electrical and electronic equipment, please contact your dealer or

supplier for further information.

Information on Disposal in other Countries outside the European Union

This symbol is only valid in the European Union.

If you wish to discard this product, please contact your local authorities or dealer and ask for

the correct method of disposal.

Panasonic Corporation

Web Site : https://panasonic.net/cns/projector/

© Panasonic Corporation 2012

LED

Power button

Button

Operating Instructions

Interactive Pointer

Model No.

Thank you for purchasing this Panasonic product.

• Before using this product, please read this

instructions and "LightPenII: Operation Manual"

completely, and save this manual for future use.

3) Pressing the button once has the same

function as left-clicking a mouse. Press and

hold the button to drag. In pen mode, you can

draw lines.

Attention

On status will consume battery power. When not in use,

press the power button to turn the power off. (Press the

button to confirm that the LED does not light.)

Installing and Removing Batteries

1. Rotate the part as shown in the figure.

2. Install 2 AAA/R03 or AAA/LR03 type batteries.

*Remove the batteries in

the reverse order of installation.

EEE Yönetmeliğine Uygundur.

EEE Complies with Directive of Turkey.

Commercial Use

ET-PNT100

ENGLISH

Printed in Taiwan

1LG6P1P1024-- (IJDV)

TQZJ712-1