Page 1
ASYNCHRONOUS NETWORK I/F KIT BKMA-7045 INSTALLATION MANUAL 1st Edition Serial No. 10001 and Higher...
Page 2
Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. BKMA-7045...
The following is a summary of all the section for understanding the contents of this manual. Section 1 Installation Explains the overview of the BKMA-7045, how to install the BKMA-7045 to the MAV-70XGI, and the connector and cable information for peripheral equipment connections, etc. Section 2...
The BKMA-7045 asynchronous network I/F kit can be connected to the gigabit Ethernet by attaching the MAV-70XGI. The BKMA-7045 needs to be used with a gateway PC. For the PCs that can be connected, contact your local Sony Sales Office/Service Center.
. Attach the board to the MAV-70XGI expansion slot. The board needs to be attached to a lower empty slot. BKMA-7045 MAV-70XGI (Rear side) . Stick the slot label (supplied with the BKMA-7045) after the board installation to prevent the incorrect insertion Board lever Board lever when the board replacing.
-1- -2- -3- -4- -5- -6- *7* -8- EXT232C Rdy Rdy Non Non Rdy Rdy Rdy Rdy 2. Select “Select” using the buttons and select the slot number into which the BKMA-7045 buttons. Then press the [ENTER] button. is inserted using the > Exit...
BKMA-7045 Matching Connector/Cable Panel Indication Connector/Cable Sony Part No. SCSI Cable corresponding to ULTRA2 (LVD) SCSI 1-769-670-21 1-6. Installing the Software Install the software in the CD-ROM supplied with the unit. (For the installing procedure, refer to the “Readme”...
Page 12
(fixed selection) If the data of the selected area is damaged, performs the code on flash bank0. ON : Performs the code on flash bank0. (fixed selection) S501-3 to 8 : Factory use S1001 (E-4) Factory use 2-2 (E) BKMA-7045...
Page 13
Lights up when the SCSI bus in the LVD mode D1007 (F-3) Orange SE indicator Lights up when the SCSI bus in the SE mode ND401 (B-6) 7SEG indicator Displays the operating state of the board by 2-digit number 2-3 (E) BKMA-7045...
+3.3 V DC : 2.5 A (supplied from the MAV-70XGI) Power consumption 9.3 W Input/Output Gateway PC connection interface terminals (68-pin wide SCSI connector ) : 2 ULTRA2 (LVD) SCSI signal 80 Mbyte/s Design and specifications are subject to change without notice. 2-4 (E) BKMA-7045...
Page 15
The material contained in this manual consists of information that is the property of Sony Corporation. Sony Corporation expressly prohibits the duplication of any portion of this manual or the use thereof for any purpose other than the operation or maintenance of the equipment described in this manual without the express written permission of Sony Corporation.