Summary of Contents for Honeywell Ex-Or MS1200PMBF
Page 1
Haydock Lane, Haydock, Merseyside WA11 9UJ the packaging and product should be disposed of via a Tel: +44 (0)1942 719229 suitable recycling centre. Fax: +44 (0)1942 508753 Do not dispose of with normal household waste. Email: [email protected] Do not burn. www.ex-or.com W5100A...
Page 2
Mid-Bay LightSpot with photocell: MS1200PMBF This is a high performance presence detector with photocell. In all operating modes, the photocell can hold lights off as a vacant area becomes occupied, and if the light level falls too low during the period of occupancy, the lights switch on.
Page 3
Commissioning The factory default settings will be appropriate for most applications. However, the installer does have the facility to re- programme a wide range of parameters using an infrared programming tool. The full range of parameters is accessible via the HP2000; the HP18 offers different/limited programming options. Please read carefully the operating instructions that accompany the programmer prior to performing a programming operation.
Setting the Photocell If the lights are not already on, switch them on manually by pressing ‘Utilities/User Remote/Luminaire+/OK’ [HP2000] or ‘On’ [HP18]. Fluorescent lights do not reach full output until up to 15 minutes after being switched on, so ensure that the lights are fully warmed up before continuing. This stage may be omitted if the intention is to operate the detector’s photocell in Passive Mode only [the detector must have already been programmed to Passive Mode].