Page 1
BLACK & DECKER REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT, GIVE US A CALL. YOUR • Before operating, make sure that either the blower or vacuum tube assembly is locked in place.
Page 2
WARNING: Shock Hazard. To reduce the risk of electrical shock; do not expose to rain, do not use on wet surfaces. Store indoors. WARNING: Cut Hazard. Turn off and unplug unit, then wait until fan stops or at least 10 seconds before removing the blower or vacuum tube assemblies.
Servicing of Double Insulated Appliances Your Blower/Vac is double-insulated to give you added safety. In a double insulated appliance, two systems of insulation are provided instead of grounding. No grounding means is provided on a double insulated appliance, nor should a means for grounding be added to the appliance.
Page 4
ASSEMBLY FOR BLOW MODE WARNING: Before attempting any of the assembly steps below, ensure product is switched off and disconnected from the power supply. BLOW TUBE ASSEMBLY (FIGURES 1-4) • Ensure grill cover is attached to the power head. If not, attach cover as shown in the inset of figure 1.
• To turn tool OFF, rotate the knob counterclockwise to the off position (0). MODEL LH4500 Your blower vac is fitted with a two speed switch located on the top of the power head below the handle. • To use in low speed, rotate the knob clockwise to Position I. To use in high speed, rotate the knob clockwise to Position II.
Page 6
MODEL BL1500 Your blower is fitted with a single speed switch located on the top of the power head below the handle. • To turn the tool ON, rotate the knob clockwise to Position I. • To turn tool OFF, rotate the knob counterclockwise to the off position (0).
As the bag fills the power of the suction will decrease, turn the blower/vac off and unplug from power supply. FOR LH5000 BAG: • Empty the shoulder collection bag by sliding the retaining bar off the bottom of the bag as shown in figure 14.
Important To assure product SAFETY and RELIABILITY; repairs, maintenance and adjustments (other than those listed in this manual) should be performed by authorized service centers or other qualified service organizations, always using identical replacement parts. SERVICE INFORMATION All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black &...
Page 9
SOUFFLEURS ET ASPIRATEURS-SOUFFLEURS BL1500 ISITEZ ISITEZ POUR POUR AVANT DE RETOURNER CE PRODUIT POUR QUELQUE RAISON QUE CE SOIT, AVANT D’APPELER, AYEZ EN MAIN LE N° DE CATALOGUE ET LE CODE DE DATE. DANS LA PLUPART DES CAS, UN REPRÉSENTANT DE BLACK & DECKER PEUT TÉLÉPHONE.
Page 10
Avertissement : Importantes Mesures de Sécurité LIRE ET COMPRENDRE TOUTES LES DIRECTIVES AVANT D’UTILISER L’OUTIL. AFIN DE RÉDUIRE LES RISQUES DE BLESSURES • Avant toute utilisation, s’assurer que tous ceux qui se servent de l’outil lisent et comprennent toutes les mesures de sécurité et tout autre renseignement contenus dans le présent guide.
AVERTISSEMENT : RISQUE DE CHOC ÉLECTRIQUE. Afin de minimiser les risques de secousses électriques, protéger de la pluie, ne pas s’en servir sur des surfaces mouillées et ranger à l’intérieur. AVERTISSEMENT : RISQUE DE COUPURE. Arrêter et débrancher l’appareil. Attendre au moins 10 secondes ou jusqu’à ce que le ventilateur s’arrête complètement avant de retirer l’assemblage de la souffleuse ou du tube d’aspiration.
Page 12
ASSEMBLAGE POUR LE MODE ASPIRATION SAC À BANDOULIÈRE (FIG. 5) • Fixer le sac à bandoulière au bloc-moteur comme montré à la figure 5. TUBE D’ASPIRATION (FIGURE 6, 7, 8) • Les tubes d'aspiration doivent être assemblés avant de s'en servir. •...
MODE ASPIRATEUR (FIGURE 13) (UNIQUEMENT MODÈLES LH4500 ET LH5000) UTILISATION EN MODE ASPIRATION : AVERTISSEMENT : s’assurer que l’appareil est éteint et débranché de sa source d’alimentation. Fixation du sac à bandoulière à l’appareil : • Retirer le tube de soufflage. •...
Problème • L’appareil refuse de démarrer. • L’appareil refuse de démarrer. • L’appareil est coincé ou bourré. Pour obtenir de l’aide avec l’outil, consulter notre site Web www.blackanddecker.com pour l’emplacement du centre de réparation le plus près ou communiquer avec l’assistance BLACK & DECKER au 1-800-544-6986. Imported by / Importé...
Page 15
SOPLADORA Y ASPIRADORAS SOPLADORAS MANUAL DE INSTRUCCIONES BL1500 ANTES DE DEVOLVER ESTE PRODUCTO POR CUALQUIER MOTIVO, LLAME AL ANTES DE LLAMAR, TENGA EL NÚMERO DE CATÁLOGO Y EL CÓDIGO DE FECHA PREPARADOS. EN LA MAYORÍA DE LOS CASOS, UN REPRESENTANTE DE BLACK &...
Page 16
ADVERTENCIA: ADVERTENCIAS E INSTRUCCIONES POR FAVOR LEA CUIDADOSAMENTE TODAS LAS INSTRUCCIONES ANTES DE USAR LA UNIDAD. Para reducir el riesgo de lesiones: • Antes de cualquier uso, asegúrese que cualquier persona que vaya a utilizar esta herramienta lea y comprenda todas las instrucciones de seguridad y la información contenida en este manual.
Servicio a aparatos con doble aislamiento Su Soplador/Aspiradora cuenta con doble aislamiento para brindarle protección añadida. En los aparatos con doble aislamiento, se cuenta con dos sistemas de aislamiento en lugar de conexión a tierra. No se proporciona ningún medio de aterrizaje en un aparato con doble aislamiento, ni se requiere añadirle ninguno.
Page 18
Ensamblaje del tubo de aspirado • Los tubos de aspirado deben ensamblarse entre sí antes de usarse. • Alinear las muescas y los triángulos del tubo superior e inferior. figure 6) • Haga coincidir las muescas y los triángulos en los tubos superior e inferior. (Nunca opere sin haberlos ensamblado.) •...
Si esto ocurre, el rendimiento de la unidad bajará. Esta parte puede limpiarse con una vara de madera, como se muestra en la figura 16, luego de desconectar la unidad de la fuente de alimentación. Su soplador aspiradora Blower/Vac debe guardarse en un lugar seco.
Problema • La unidad no enciende. •La unidad no enciende. • La unidad está atascada u obstruida. Para conocer la ubicación del centro de mantenimiento más cercano a fin de recibir ayuda con su producto, visite nuestro sitio Web www.blackanddecker.com o llame a la línea de ayuda BLACK & DECKER al 55-5326-7100 Para reparación y servicio de sus herramientas eléctricas, favor de dirigirse al Centro de Servicio más cercano: CULIACAN, SIN...