Related Manuals for Honeywell Bendix King Silver Crown Plus KX 155A
Summary of Contents for Honeywell Bendix King Silver Crown Plus KX 155A
- Page 1 Bendix/King Silver Crown Plus ™ Avionics Systems Pilot’s Guide Nav/Comm Systems...
- Page 2 All rights reserved. Reproduction of this publication or any portion thereof by any means without the express written permission of Honeywell International Inc. is prohibited. For further information contact the Manager, Technical Publications; Honeywell Business & General Aviation; One Technology Center; 23500 West...
- Page 3 Silver Crown Plus Pilot’s Guide ATTENTION The operation of the GPS Navigation, Multi-Function Display and/or Traffic Information Services components of your particular Silver Crown Plus System are covered in separate publications. Choose the publication pertaining to your installation from the list below: Description Publication Part Number KMD 150 Multi-Function Display/GPS...
- Page 4 KX 155A/165A KX 155A and KX 165A VHF Communication/Navigation Transceivers KX 155A and KX 165A Operation (25 kHz Versions) All controls required to operate the KX 155A and KX 165A are located on the unit front panel. “T” Indicates Mic Button is Being Depressed “R”...
- Page 5 Silver Crown Plus Pilot’s Guide COMM Transceiver To tune the radio to the desired operating frequency, the desired fre- Rotate the VOL knob clockwise quency must be entered into the stand- from the OFF position. Pull the VOL by display (Figure 2) and then the knob out and adjust for desired listen- transfer button must be pushed.
- Page 6 KX 155A/165A The transceiver is always tuned to the frequency appearing in the ACTIVE dis- play. It is therefore possible to have two different frequencies stored in the ACTIVE and STANDBY displays and to FIGURE 5 change back and forth between them at Entering channel program mode the simple push of the transfer button.
- Page 7 Silver Crown Plus Pilot’s Guide mode. The unit will also exit the channel program mode if there is no button or knob activity for 20 seconds. The channel selection mode can then be entered by momentarily pushing the CHAN button (Figure 9). “CH” is displayed next to the last used channel number.
- Page 8 KX 155A/165A ment for the ground station decoder is such that it will not respond to very rapid or “staccato” transmissions. If the first attempt at lighting the runway lights is unsuccessful, repeat with a slower, more deliberate cadence of microphone key- ing.
- Page 9 Silver Crown Plus Pilot’s Guide cause the ACTIVE frequency to be placed in blind storage and the STANDBY fre- quency (in blind storage) to be displayed in the ACTIVE window display. When the ACTIVE window is tuned to FIGURE 12 a VOR frequency, the standby frequency Nav display Active localizer frequency/ area is replaced by a three digit OBS...
- Page 10 KX 155A/165A increment/decrement knob channels the ACTIVE frequency window and depress- ing the frequency transfer button will cause the ACTIVE frequency to be placed in blind storage and the STAND- BY frequency (in blind storage) to be dis- played in the ACTIVE window display. In radial mode of operation, the right hand window of NAV display shows the radial FROM the station.
- Page 11 Silver Crown Plus Pilot’s Guide pulled out position so that both voice and ident can be heard. When this knob is pushed in, the ident tone is attenuated. The volume of voice/ident can be adjust- ed by turning this knob. Pilot Configuration This mode can be accessed by pressing and holding the Nav Mode...
- Page 12 Honeywell International Inc. One Technology Center 23500 West 105th Street Olathe, KS 66061 Telephone (913) 782-0400 FAX 913-712-1302 ©1998-2002 Honeywell International Inc. 006-18110-0000 Printed in U.S.A. Revision 4 Nov/2002...