Table of Contents
Drive Shaft (Axle) Boots Inspection
Check drive shaft boots (wheel side and differential side) for
leaks, detachment, tear or other damage.
Replace boot as necessary.
Propeller Shafts (4WD) Inspection
1) Check propeller shaft connecting bolts for looseness. If
looseness is found, tighten to specified torque.
2) Check propeller shaft joints for wear, play and damage.
If any defect is found, replace.
3) Check propeller shaft center support for biting of foreign mat-
ter, crack, abnormal noise and damage. If any defect is
found, replace.
Manual Transmission Oil Inspection (G10/M13
Engines)
1) Inspect transmission case for evidence of oil leakage.
Repair leaky point if any.
2) Make sure that vehicle is placed level for oil level check.
3) Remove oil filler/level plug (1) of transmission.
4) Check oil level.
Oil level can be checked roughly by means of filler/level plug
hole. That is, if oil flows out of level plug hole or if oil level is
found up to hole when level plug is removed, oil is properly
filled.
If oil is found insufficient, pour specified oil up to level hole.
For specified oil, refer to "Manual Transaxle Oil Change" in
Section 7A or 7A2.
5) Apply sealant to filler/level plug and tighten it to specified
torque.
Manual Transmission Oil Replacement
Replace manual transmission oil referring to "Manual Transaxle
Oil Change" in Section 7A (G10 engine), 7A2 (M13 engine) or
7A3 (Z13DT engine).
MAINTENANCE AND LUBRICATION 0B-23
- Quick Links:
- English
Hide quick links:
Chapters
Table of Contents
