Honeywell Performance Series Quick Installation Manual

HPW2P1 WDR 1080P Pin-hole Camera

Thank you for purchasing a Honeywell Performance Series IP camera.

Follow the instructions in this guide to install and log in to your camera.

For instructions on configuring the camera, refer to the Performance

Series IP Cameras User Guide on the installation CD that came with your

camera.

If you require additional assistance, contact Tech Support (contact info

is listed on the back page).

CAUTION

RISK OF ELECTRIC

SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC

SHOCK, DO NOT REMOVE THE COVER.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE

PERSONNEL.

WARNING

To ensure compliance with electrical safety standards, this product is intended

for use with a Listed Power Adapter marked "Limited Power Source" or "LPS" on

the unit, output rated to 12 VDC, minimum 0.33 A, TMA=60 deg C, or from Power

over Ethernet (PoE) provided by Listed Information Technology Equipment

meeting IEEE 802.3af PoE standard.

WARNING

The Ethernet connection is not intended to be connected to exposed (outside

plant) networks. Do not connect two power sources to the camera at the same

time.

CAUTION

Invisible LED radiation (850 nm). Avoid exposure to beam.

•

Read and keep these instructions.

•

Do not aim the camera toward a bright light source for extended periods to prevent damage to

the imager. Avoid operating the unit under or close to unstable light sources (may cause

flickering), or close to fluorescent lamps or objects reflecting light.

•

Do not touch the camera lens.

•

Do not drop the camera or subject it to physical shock.

•

Do not use a strong or abrasive detergent when cleaning the camera.

THIS SYMBOL INDICATES THAT

DANGEROUS VOLTAGE

CONSTITUTING A RISK OF

ELECTRIC SHOCK IS PRESENT

WITHIN THE UNIT.

THIS SYMBOL INDICATES THAT

IMPORTANT OPERATING AND

MAINTENANCE INSTRUCTIONS

ACCOMPANY THIS UNIT.

•

Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where

the operating temperature is outside the recommended range of -22°F to 140°F (–30°C to

60°C).

Note

Do not apply power to the camera before completing installation.

Confirm the installation surface can support at least three times the weight of the

camera.

Before you begin, check that you have received all of the parts listed below. If any parts are missing

or damaged, contact your dealer immediately.

•

•

Camera

•

Installation CD

Preparing the Mounting Surface and Mounting the Camera

Inspect the site where you want to install the camera. The mounting surface must be flat and

capable of supporting at least three times the weight of the camera.

1.

Install the camera together with the bracket on the mounting surface and secure the

installation screws firmly.

2.

Connect the camera's connectors to power, network and audio in/out.

3.

Adjust the camera angle and tighten the adjusting screws.

Camera body

Adjusting screws

Bracket

Mounting screws

(not included)

Mounting surface

Logging On to the Camera

If the camera is connected to the PoE port of a Honeywell Embedded NVR, you can log on to the

camera directly from the NVR.

Quick installation guide

Power 12 VDC

Audio In

(Yellow) Audio Out

Network