Motorola GTX Installation Manual
Motorola GTX Installation Manual

Motorola GTX Installation Manual

900mhz two way mobile radio
Hide thumbs Also See for GTX:
GTX
Mobile Radio
Installation Manual
6880907Z66-O
Table of Contents
loading

Summary of Contents for Motorola GTX

  • Page 1 Mobile Radio Installation Manual 6880907Z66-O...
  • Page 2: Computer Software Copyrights

    Agreement. You agree that this is the complete and exclusive statement of the agreement between You and Motorola and that any modification of these terms shall be made only by mutual agreement and evidenced by written amendment signed by both parties.
  • Page 3: Table Of Contents

    Table of Contents Section 1 Introduction Scope of Manual ................1-1 How to use this Manual.
  • Page 4 Table of Contents GTX Mobile Radio Installation Manual 6880907Z66-O June, 2000...
  • Page 5: Introduction

    2 sub-part J. Motorola Parts. If only a generic part is listed, the part is not normally available through Motorola. If no parts • American National Standards Institute (ANSI) /...
  • Page 6: Electromagnetic Interference/Compatibility

    Introduction GTX Mobile Radio Installation Manual Electromagnetic Interference/Compatibility • Institute of Electrical and Electronic Engineers Potentially Explosive Atmospheres (IEEE) C95.1-1999 Edition. WARNING • National Council on Radiation Protection and Measurements (NCRP) of the United States, Turn off your two-way radio when you are in any area with a potentially explo- Report 86, 1986.
  • Page 7: Selecting An Antenna Site

    GTX Mobile Radio Installation Manual Introduction Mobile Antenna Installation least the minimum distance away from a properly Antenna Installation Procedure installed, externally-mounted antenna. Mount the antenna according to the instruc- Table 1-1 lists the minimum distance for several differ- tions provided with the antenna kit. Run the ent ranges of rated radio power.
  • Page 8 Introduction GTX Mobile Radio Installation Manual Mobile Antenna Installation Accessory Connector covered with gasket Antenna Power Cable Connector Vehicle Chassis Ground (black) To Battery + via fuse (red) 30/35 Watt Radio Accessory Connector covered with gasket Power Vehicle Connector Chassis...
  • Page 9: Installation

    Power Protection Circuitry • Portable Drill The GTX mobile you are installing has been tested for • Hammer proper transmitter power output before leaving the factory. Each radio is set to the proper output power •...
  • Page 10: Radio Mounting

    Installation GTX Mobile Radio Installation Manual Starting The Installation Radio Mounting 3. From inside the vehicle, feed the red and black leads (without lugs attached) through the access hole and into the engine compart- Mounting Trunnion ment. See Figure 2-1.
  • Page 11: Mounting Trunnion Installation

    GTX Mobile Radio Installation Manual Installation Starting The Installation 8. Connect the power cable red lead from the fuse holder to the positive (+) battery termi- nal. Make sure the adapter cable is connected to the main power cable red lead.
  • Page 12: Mounting Trunnion Installation

    Installation GTX Mobile Radio Installation Manual Starting The Installation Figure 2-5. 30 W & 35 W Transmission Hump Mounting Mounting Trunnion Installation (12 W & 15 W) Select the location to mount your radio - either on the transmission hump or under the dash- board.
  • Page 13 GTX Mobile Radio Installation Manual Installation Starting The Installation 7. Connect the antenna cable connector to the radio antenna connector on the rear of the radio. See Figure 2-7. Accessory Connector covered with gasket 8. Mount the microphone clip to a convenient spot near your radio, and ensure that it is grounded.
  • Page 14: External Speaker Installation

    Installation GTX Mobile Radio Installation Manual Starting The Installation External Speaker Installation Remove the speaker from the trunnion bracket by loosening the two M5 wing screws. Choose a place to mount the speaker. Using the trunnion bracket as a template, mark the locations of the three mounting holes.
  • Page 15: Accessory Connector Procedures

    Section 3 Accessory Connector Procedures This section provides the connection procedures for the various accessories of the GTX Mobile Radio. The diagrams are self-explanatory and wherever applicable relevant information is included. The accessory connections shown are not compatible to other models of Motorola radios. Check the appropriate accessory or technical manual for fur- ther information.
  • Page 16: Speaker, Microphone, Ptt Switch & Ignition Sense

    Figure 3-2 shows the connection diagram of the Exter- nal Alarm, Relay and Cable. Speaker The GTX radios use a 7.5 Watt speaker. Refer to Figure 3-3. This speaker can be connected to the accessory connec- tor located on the rear side of the radio between pin 1 and pin 16.
  • Page 17: List Of Accesorries

    Power Supply and Cable (less than or equal to 25 W) HKN9088 Mobile Mini-U Antenna 8 ft. Adapter Cable HMN3000 Desk Micophone Manuals/Kits 6880907Z20 GTX LTR User’s Guide (English/French) 6880907Z21 GTX Privacy Plus User’s Guide (English/French) 6880905Z99 Service Manual RVN4150 GTX Radio Service Software Kit June, 2000 6880907Z66-O...
  • Page 18 Accessory Connector Procedures GTX Mobile Radio Installation Manual List of Accesorries 6880907Z66-O June, 2000...
  • Page 19 Motorola, Inc. Radio Products Group 1000 W. Washington St. Mt. Pleasant, IA 52641 Copyright © 2000 Motorola, Inc. All Rights Reserved 6880907Z66-O Printed In U.S.A.

Table of Contents