Quick Links
IR Dongle
v2.0
Quick Start Guide
Work with IR Dongle
v2.0 in the field
This dongle is for use with compatible
phones to enable IR (infrared) for field
configuration and grouping of EasyAir,
office/industry sensor families.
Importance of installer's positioning for correct commissioning
of SNH200 using IR Dongle
For compatible phones, refer to the Technical Downloads.
Tips for Use:
✓
✓
✓
Note: Remember to switch off the LEDs when not in use to
save battery and for longer lifetime
Working with Philips Field Apps
You must first register for Philips Field Apps to receive a
username and password, then download Philips Field Apps
from Google Play Store.
Luminaires
Ordering data
Commercial product name
IR Dongle v2.0
Technical specifications
Maximum mounting height
16m/50ft
Allow all pop-up messages in Philips Field Apps (e.g. "Allow
Philips Field Apps to record audio? Allow Philips Field Apps
to access photos, media and files on your device?").
Aim the emitter of the dongle at the target luminaire using
the IR dongle and check the light behavior according to
steps in the App to confirm the command gets executed.
(light dimmed, light blinks twice, etc.)
Invert Signal in the Preferences within app when the LED
blinks 6 times.
12NC
929001678906
Ambient temperature range
From -10 ºC to 50 ºC
December 2018
Related Manuals for Philips IR dongle
Summary of Contents for Philips IR dongle
- Page 1 Aim the emitter of the dongle at the target luminaire using ✓ the IR dongle and check the light behavior according to steps in the App to confirm the command gets executed. This dongle is for use with compatible (light dimmed, light blinks twice, etc.)
- Page 2 LED blinks 3 times: Signal LED OK to proceed (red in colour) LED blinks 6 times: “Invert Signal” in Preferences of Philips Field Apps. Short Distance Selection Switch (office) 2 LEDs are available for use depending upon the application: Long •...
- Page 3 IR Dongle v2.0 Battery Replacement The battery can be replaced by opening the IR dongle by 2 screws. Type of battery: CR2032. Follow the steps shown below to replace the battery. Recommended suppliers: • Panasonic • Varta • Energizer Disassemble the IR Dongle and replace the battery Once, the battery is replaced, connect the part with with identical polarity as shown on Figure 1.
- Page 4 The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract, unless otherwise agreed by Signify. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.