Sanyo LNS-S02Z Replacement /Installation Instructions
  1. Manuals
  2. Brands
  3. Sanyo Manuals
  4. Projector Accessories
  5. Replacement /installation instructions

Sanyo LNS-S02Z Replacement /Installation Instructions

Sanyo lcd projector zoom lens replacement and installation procedure
Hide thumbs
1
2
3
4

Quick Links

LCD PROJECTOR LENS
MODEL NO. LNS-S02Z
LENS REPLACEMENT
AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installation Manual corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector. Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.
TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL
Refer to the Installation Manual corresponding to your projector.
(See the chart below.)
Type of the Cabinet
Other than the above cabinet
design.
Reference Installation Manual
Refer to this manual.
Refer to the Installation Manual
supplied with the Projector.
loading

Related Manuals for Sanyo LNS-S02Z

Summary of Contents for Sanyo LNS-S02Z

  • Page 1 LCD PROJECTOR LENS MODEL NO. LNS-S02Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector.
  • Page 2 NOTES ON LENS INSTALLATION • Lens installation and replacement should be made by the qualified service personnel. • Be sure to install the lens following this procedure precisely. • The lens cover is on the lens for protection. Be sure to replace the lens cover before installation.
  • Page 3 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1) 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). 4.
  • Page 4 ❋ Figure shown inside of the cabinet. INSTALL THE LIGHT-BLOCK SHEET. (See figure-5) Install the light-block sheet around the lens as shown in the illustration. (Use the sheet included with the lens.) Set the light-block sheet, so that the large rounder side is set over the lens.